Yes I just tested like this..
What i did was:
ifconfig -a gives me logical names such as: __tmp1035166962 , ethX
and ethtool -p __tmp1035166962 makes blinking in the network port. My
problem is resolved.
Thanks a lot guys. Appreciate it.
Paras.
On Fri, Oct 15, 2010 at 12:12 PM, Bowie Bailey <Bowie_Bailey@xxxxxxx> wrote:
> On 10/15/2010 1:10 PM, Bowie Bailey wrote:
>> On 10/15/2010 12:44 PM, Paras pradhan wrote:
>>> On Fri, Oct 15, 2010 at 3:57 AM, Peter Kjellstrom <cap@xxxxxxxxxx> wrote:
>>>> On Thursday 14 October 2010, Paras pradhan wrote:
>>>> ...
>>>>> I have eight nics and its getting difficult to me which MAC id
>>>>> represents which physical port. Any way to find this?
>>>> Have a look at the "-p" option to ethtool
>>> It would be useful (to me) if I can use mac address instead of
>>> interface name in -p option.
>> Try this script (untested):
>>
>> --------------------------------------------
>> #!/bin/bash
>> ETH=`ifconfig | grep -i $1 | cut -d ' ' -f 1`
>> echo "Blinking $ETH - $1"
>> ethtool -p $ETH 30
>> --------------------------------------------
>>
>> Just call it with the mac address as an argument. It will find the
>> interface with ifconfig and then call ethtool to blink the lights for 30
>> seconds.
>>
>> (Assuming your NIC supports ethtool. The system I tried to test this on
>> was not supported...)
>
> oops...
>
> Make that "ifconfig -a" in the script to find inactive interfaces.
>
> --
> Bowie
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
