Nothing in the dmesg except this:
Broadcom NetXtreme II Gigabit Ethernet Driver bnx2 v2.0.2 (Aug 21, 2009)
eth0: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit
133MHz found at mem e6000000, IRQ 16, node addr 0024e848f03d
eth1: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit
133MHz found at mem e8000000, IRQ 17, node addr 0024e848f03f
eth2: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit
133MHz found at mem ea000000, IRQ 19, node addr 0026b9662f43
eth3: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit
133MHz found at mem ec000000, IRQ 20, node addr 0026b9662f45
Paras.
On Wed, Oct 13, 2010 at 5:47 PM, Les Mikesell <lesmikesell@xxxxxxxxx> wrote:
> On 10/13/2010 5:26 PM, Paras pradhan wrote:
>> Hi,
>>
>> I don't have ifcfg-eth1 in my /etc/sysconfig/network-scripts. But when
>> I do ifconfig eth1 I can see output as below. If I do ifconfig eth12 ,
>> I don't see anything which i am assume is normal.
>>
>>
>> eth1 Link encap:Ethernet HWaddr 00:24:E8:44:DB:CC
>> BROADCAST MULTICAST MTU:1500 Metric:1
>> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 txqueuelen:1000
>> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
>> Interrupt:17 Memory:e8000000-e8012800
>>
>>
>> Don't know why and how this is happening.
>
> The output of 'dmesg' should show some details about the device detected
> as eth1.
>
> --
> Les Mikesell
> lesmikesell@xxxxxxxxx
>
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
