Re: Raid 10 questions...2 drive

[Tom Bishop <bishoptf@xxxxxxxxx>]

Thanks for all of the inputs...I finally came across a good article summarizing what I needed, looks like I am going to try to the f2 option and then do some testing vs the default n2 option.  I am building the array as we speak but it looks like building the f2 option will take 24hrs vs 2hrs for the n2 option....this is on 2 1TB hdd....

On Sat, Sep 25, 2010 at 3:04 PM, Ross Walker <rswwalker@xxxxxxxxx> wrote:

On Sep 25, 2010, at 1:52 PM, Tom H <tomh0665@xxxxxxxxx> wrote:

> On Sat, Sep 25, 2010 at 11:48 AM, Ross Walker <rswwalker@xxxxxxxxx> wrote:
>> On Sep 25, 2010, at 9:11 AM, Christopher Chan <christopher.chan@xxxxxxxxxxxxxxx> wrote:
>>> Jacob Bresciani wrote:
>>>> RAID10 requires at least 4 drives does it not?
>>>>
>>>> Since it's a strip set of mirrored disks, the smallest configuration I
>>>> can see is 4 disks, 2 mirrored pairs stripped.
>>>
>>> He might be referring to what he can get from the mdraid10 (i know, Neil
>>> Brown could have chosen a better name) which is not quite the same as
>>> nested 1+0. Doing it the nested way, you need at least 4 drives. Using
>>> mdraid10 is another story. Thanks Neil for muddying the waters!
>
>
>> True, but if you figure it out mdraid10 with 2 drives = raid1, you would need 3
>> drives to get the distributed copy feature of Neil's mdraid10.
>
> I had posted earlier (
> http://lists.centos.org/pipermail/centos/2010-September/099473.html )
> that mdraid10 with two drives is basically raid1 but that it has some
> mirroring options. In the "far layout" mirroring option (where,
> according to WP, "all the drives are divided into f sections and all
> the chunks are repeated in each section but offset by one device")
> reads are faster than mdraid1 or vanilla mdraid10 on two drives.

If you have any two copies of the same chunk on the same drive then redundancy is completely lost.

Therefore without loosing redundancy mdraid10 over two drives will have to be identical to raid1.

Reads on a raid1 can be serviced by either side of the mirror, I believe the policy is hard coded to round robin. I don't know if it is smart enough to distinguish sequential pattern from random and only service sequential reads from one side or not.

>> For true RAID10 support in Linux you create multiple mdraid1 physical
>> volumes, create a LVM volume group out of them and create logical
>> volumes that interleave between these physical volumes.
>
> Vanilla mdraid10 with four drives is "true raid10".

Well like you stated above that depends on the near or far layout pattern, you can get the same performance as a raid10 or better in certain workloads, but it really isn't a true raid10 in the sense that it isn't a stripe set of raid1s, but a distributed mirror set.

Now don't get me wrong I'm not saying it's not as good as a true raid10, in fact I believe it to be better as it provides way more flexibility and is a lot simpler of an implementation, but not really a raid10, but something completely new.

-Ross

_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos

_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos