On Dec 18, 2005, at 5:37 PM, lnthai2002@xxxxxxx wrote:
>
>
> -----Original Message-----
> From: Steve Huff <shuff@xxxxxxxxx>
> To: CentOS mailing list <centos@xxxxxxxxxx>
> Sent: Sun, 18 Dec 2005 18:18:23 -0500
> Subject: Re: Where is the kernel source code???
>
> On Dec 18, 2005, at 3:41 PM, Jim Perrin wrote:
>
> > Long complicated answer: you'd need to get the src rpm, edit the
> > .config used to add support for the driver, rebuild the rpm.... etc.
>
> this is not quite correct; rather that messing with the kernel
> SRPM, you should also be able to pull down the kernel-source RPM:
>
> yum -y install kernel-source
>
> this will create /usr/src/linux-<kernel version>, which contains
> the kernel source.
>
> this doc is old, but you may be able to compile a custom kernel
> using a similar procedure:
>
> http://www.redhat.com/docs/manuals/linux/RHL-9-Manual/custom-guide/
> s1-cus
> tom-kernel-modularized.html
>
> but i'd add my voice to those recommending that you NOT compile
> you own kernel, and instead use the centosplus kernel, especially
> if it contains the module(s) you need.
>
> -steve
>
> ---
> If this were played upon a stage now, I could condemn it as an
> improbable fiction. - Fabian, Twelfth Night, III,v
>
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
> How do i know that the centOSplus kernel has support for my device
> (in my case bt848 capture device). I must see the config file
> right? But rpm doesnt put that config file into /boot
> Thanks, guys
> NHUT THAI LE
> ______________________________________________________________________
> __
> Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-
> leading spam and email virus protection.
Sometimes you need to compile your own drivers, since no one kernel
has all drivers. Especially out of kernel drivers.
