you can use netdevice=(eth*) and/or ksdevice=(eth*) in the kernel
command line when kickstarting.... you can also set the MAC in
/etc/sysconfig/network-scripts/ifcfg-eth* to whatever port you want...
... thanks
- doug
************************************************************************
Doug Zeman \ \ | __ \ ____ | Phone: 408 7747674
CAD Sys Eng II / \ | _/ | | | | Cell : 408 7187466
CA MicroProc Div ____ \ | | | | | | Fax : 408 7747811
Sunnyvale, CA _/ _\_| _| _____/ ____/ \| doug.zeman@xxxxxxx
************************************************************************
sudo Yang wrote:
> One of my systems have two onboard NICs which uses the e100 and e1000
> drivers (yes, the interfaces are not the same). This system kickstart
> fine with CentOS 3.x. I recently tried to rekick it with CentOS 4.x
> but was unsuccessful in doing so. When kicking CentOS 4.1, the
> interfaces are swapped around, i.e. eth0 becomes eth1 and eth1 becomes
> eth0 (as described at
> http://marc.theaimsgroup.com/?l=linux-kernel&m=104888957013124&w=2).
> Is there a way to fix the interface during kickstart?
>
> Unfortunately, because we have so many different types of systems,
> simply swapping the cables is not a good idea because it complicates
> management.
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
>
