On Wed, August 3, 2005 8:01 am, BRUCE STANLEY said: > > > > --- Rohan Walsh <rohan_walsh@xxxxxxxxxxxx> wrote: > >> On Tue, 2005-08-02 at 23:58 -0400, Kanwar Ranbir Sandhu wrote: >> > On Tue, 2005-02-08 at 19:57 -0700, BRUCE STANLEY wrote: >> > > I am getting occasional seek error on my boot drive. >> > > The messages are as follows: >> > > >> > > pshda: dma_intr: status = 0x51 { Drive ReadySeekComplete Error } >> > > hda: dma_intr: error= 0x84 { DriveStatusError BadCRC } >> > > ide: failed opcode was: unknown >> > >> > I've recently seen similar errors on an old server here, and all my >> > Googling seems to indicate an early sign of imminent drive failure. >> > >> > Some people reported resolving the issue by making changes to DMA >> > settings with hdparm, or changing something in the BIOS. However, in >> > most cases, the recommendations were: >> > >> > 1. Backup data, ASAP, and wait for failure before moving to new disk >> > 2. Use fdisk to map out the bad sectors. >> > 3. Get a new HD, ASAP. >> >> I used these errors as a good reason to buy a bigger drive and the new >> drive had the same error messages. After testing with seagates tool, I >> can find no problem with either drive. I disable dma as a temporary >> solution, but I think it is not a drive fault in my case. Do back up :) >> > > > How did you go about disabling dma? > > You only want to do that as a last resort, it makes your disk IO very slow. You would change it using hdparm ... the option would be: hdparm -d0 You can make it happen every reboot by editing the file: /etc/sysconfig/harddisks set: USE_DMA=0 and remove the # in front of it. AGAIN ... only if absolutely necessary, because it greatly slows down disk I/O. -- Johnny Hughes <http://www.HughesJR.com/>