You are the man. The below worked perfectly. :-)
On Wed, 2005-04-13 at 14:51 -0700, Johnn Tan wrote:
> ryanag@xxxxxxxxxxxxxxxx wrote:
> > I want to add two IP ranges on one NIC card (eth0 and eth0:1). Has
> > anyone done this before?
> >
> > The CentOS 4 gui keeps locking up when I try it there and the command
> > line ifconfig seems to work, but ifup always returns the error that is
> > never heard (no such device) of eth0:1
>
> If you do ifconfig, then you don't need to do ifup afterwards. It comes
> up as part of the command. ifup is if you have the device or alias
> defined and it's not up and running. For CentOS/RHEL, you define the IP
> aliases in:
> /etc/sysconfig/network-scripts
>
> In fact, assuming you want the ranges to come up after reboot, it's best
> to put them there. Note that Linux (as opposed to Solaris, I think?)
> uses eth0:0 as the first IP alias of eth0 (eth0 itself being the
> primary/non-alias IP address), not eth0:1. eth0:1 would be for the 2nd
> IP alias of eth0.
>
> But if you're doing a range, then instead of
> /etc/sysconfig/network-scripts/ifcfg-eth0:0, you'd want
> /etc/sysconfig/network-scripts/ifcfg-eth0-range0
> and then instead of IPADDR=, use IPADDR_START=starting.ip.address.here
> and IPADDR_END=ending.ip.address.here
>
> johnn
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
