On Tue, Mar 04, 2014 at 02:50:40PM +0200, Peter Peltonen wrote: > Hi, > I have a server with Supermicro X7DVL-3 (P9) motherboard, 16G ECC RAM and > LSI SAS 1068e RAID controller. I installed CentOS 6.5 64bit on the machine > without any problems, but after following the Xen setup steps at > [1]http://wiki.centos.org/HowTos/Xen/Xen4QuickStart > which installed me the kernel 3.10.32-11.el6.centos.alt.x86_64, I > encountered a problem: After "Starting certmonger [OK]" the screen went > black and the system became unresponsive: keyboard was not working > (NumLock did not respond) and SSH was not responding either. After first > lockup I increased dom0 max mem to 2G, but rebooting after that produced > the same result. The strange thing is, that after a third reboot > everything worked ok: screen went black for a moment after "Staring > certmonger [OK]" but after that the graphical login screen appeared and I > could use the system normally. The fourth reboot went ok as well. > Any ideas what could cause this kind of behaviour? > No idea really.. but what you should do is to enable/configure a serial console, probably by using the IPMI SOL, so you can capture and log all the Xen and dom0 kernel boot messages.. So we can hopefully *see* what the issue is, and not have to guess :) -- Pasi > Regards, > Peter > _______________________________________________ CentOS-virt mailing list CentOS-virt@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos-virt
