On 03.10.2012 12:34, lhecking@xxxxxxxxxxxxxxxxxxxxx wrote: >> Are you sure the VNIC is bound to the proper bridge? I'd do a "virsh >> dumpxml $domain" and compare the network settings, see if there's >> difference. > > I deleted the config and the domain is gone :( All the other domains > have > the correct settings, > > <interface type='bridge'> > <mac address='MAC:ADDRESS'/> > <source bridge='br0'/> > <model type='virtio'/> > <address type='pci' domain='0x0000' bus='0x00' slot='0x03' > function='0x0'/> > </interface> > > I am certain it was bound to the correct bridge, I use > virt-install .... --network bridge=br0,mac=$mac ... > But there is no network connection even when I try to recreate the > vm > from scratch (NetworkManager fails to configure eth0). > > # brctl show > bridge name bridge id STP enabled interfaces > br0 8000.d4ae528534db no em1 > vnet1 > vnet2 > vnet3 > vnet4 > vnet5 > vnet6 > vnet7 > virbr0 8000.5254007426a3 yes virbr0-nic > # > > _______________________________________________ > CentOS-virt mailing list > CentOS-virt@xxxxxxxxxx > http://lists.centos.org/mailman/listinfo/centos-virt There has to be some problem somewhere. Have you checked the logs? Are you sure the IP config is correct? Do you have connectivity if you use the NAT-ed virbr0? -- Sent from the Delta quadrant using Borg technology! Nux! www.nux.ro _______________________________________________ CentOS-virt mailing list CentOS-virt@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos-virt
