As I received no response on the general CentOS list, I'll repost it here as the question is about Xen virtual machine routing. This is my network setup: http://pastebin.com/kyWpTQYU Lets assume my dom0's eth2 public ip is 1.2.3.33 and my dmz network 11.22.33.96/255.255.255.224 . I have created NAT from my LAN with iptables. You can see my /etc/sysconfig/iptables here: http://pastebin.com/1FqSTvPH And this is my dom0 routing table: http://pastebin.com/gNjTFHp5 My goal: To access NFS shares on a (non-virtualized) file server in the LAN network from the domU web server in the DMZ network. What I tried: I attached the domU to both bridges using this Xen config: vif = [ "mac=00:0c:29:de:3a:fe,bridge=xenbr0","mac=00:0C:29:76:19:85,bridge=xenbr1" ] and then created two eth interfaces inside the domU mapping to the MAC addresses above, giving eth1 an IP from the DMZ (11.22.33.111) and giving eth2 an IP from the LAN (192.168.0.12). After this I mounted the NFS share from the file server (192.168.0.2). My problem: If my domU web server is connected to both LAN and DMZ using the two bridges xenbr0 and xenbr1, I can access the NFS share from the domU web server and everything else works as expected, except for one thing -- my workstations in the LAN cannot anymore access the web server: web pages do not open anymore and from the workstations I cannot ping the domU. If the web server domU is only connected to DMZ via xenbr0, the workstations can access it ok. Any advice what I am doing wrong and I could fix my setup? Regards, Peter _______________________________________________ CentOS-virt mailing list CentOS-virt@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos-virt
