Hi, Order of console kernel arguments matters, as far as I know, output goes to the last console. console=tty0 console=ttyS0,115200n8 -> boot output to ttyS0 console=ttyS0,115200n8 console=tty0 -> boot output to tty0 Maybe this could be the reason why do not see output ? -- Best Regards Markus On 11 Jun 2010, at 01:08, Lars Hecking wrote: > >> IIRC you're connected to the serial console of the guest, so if your >> software isn't setup to use the serial port nothing will happen (or >> output only garbage). > > I found instructions here > > http://blog.zelut.org/2010/05/05/configure-serial-console-access-on-centos-5/ > > and it kinda works - I can see the start of the boot process, and once > finished, I can login via serial console, but do not see the boot > output. > Still, better than nothing. > > > > --------------------------------------------------------------- > This message and any attachments may contain Cypress (or its > subsidiaries) confidential information. If it has been received > in error, please advise the sender and immediately delete this > message. > --------------------------------------------------------------- > > _______________________________________________ > CentOS-virt mailing list > CentOS-virt@xxxxxxxxxx > http://lists.centos.org/mailman/listinfo/centos-virt _______________________________________________ CentOS-virt mailing list CentOS-virt@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos-virt
