On Thu, 13 Jun 2024 10:54:12 +0200 Larysa Zaremba wrote: > > > The locking mechanisms I use here do not look pretty, but if I am not missing > > > anything, the synchronization they provide must be robust. > > > > Robust as in they may be correct here, but you lose lockdep and all > > other infra normal mutex would give you. > > I know, but __netif_queue_set_napi() requires rtnl_lock() inside the potential > critical section and creates a deadlock this way. However, after reading > patches that introduce this function, I think it is called too early in the > configuration. Seems like it should be called somewhere right after > netif_set_real_num_rx/_tx_queues(), much later in the configuration where we > already hold the rtnl_lock(). In such way, ice_vsi_rebuild() could be protected > with an internal mutex. WDYT? On a quick look I think that may work. For setting the NAPI it makes sense - netif_set_real_num_rx/_tx_queues() and netif_queue_set_napi() both inform netdev about the queue config, so its logical to keep them together. I was worried there may be an inconveniently placed netif_queue_set_napi() call which is clearing the NAPI pointer. But I don't see one. > > > A prettier way of protecting the same critical sections would be replacing > > > ICE_CFG_BUSY around ice_vsi_rebuild() with rtnl_lock(), this would eliminate > > > locking code from .ndo_bpf() altogether, ice_rebuild_pending() logic will have > > > to stay. > > > > > > At some point I have decided to avoid using rtnl_lock(), if I do not have to. I > > > think this is a goal worth pursuing? > > > > Is the reset for failure recovery, rather than reconfiguration? > > If so netif_device_detach() is generally the best way of avoiding > > getting called (I think I mentioned it to someone @intal recently). > > AFAIK, netif_device_detach() does not affect .ndo_bpf() calls. We were trying > such approach with idpf and it does work for ethtool, but not for XDP. I reckon that's an unintentional omission. In theory XDP is "pure software" but if the device is running driver will likely have to touch HW to reconfigure. So, if you're willing, do send a ndo_bpf patch to add a detached check.
