On Wed, Apr 3, 2024 at 10:56 AM Andrii Nakryiko <andrii.nakryiko@xxxxxxxxx> wrote: > > On Wed, Apr 3, 2024 at 10:06 AM Vincent Li <vincent.mc.li@xxxxxxxxx> wrote: > > > > Hi, > > > > Once I enabled the open source firewall IPfire kernel 6.6.15 > > DEBUG_INFO_BTF, the IPfire ISO image is increased from about 450MB to > > about 1.5GB, I suspect because IPfire has many driver modules to > > BTF can't be that big. I think you just get all the DWARF for modules > and vmlinux itself. DWARF is necessary to generate BTF during the > build time, but it can be stripped out afterwards, leaving just (much > smaller) BTF intact. ok good to hear that :). I am new to this, how to strip kernel/modules DWARF after kernel/modules being built? > > > support as many hardware as possible, pahole generated BTF for all > > these modules, that could increase the size of the ISO image, so I > > wonder if I could disable modules BTF only but keep vmlinux BTF, or > > maybe selectively enable BTF for some modules, but not other modules? > > > > I found this discussion [0] making DEBUG_INFO_BTF_MODULES selectable > > independently. I am still not sure how to disable modules BTF, I tried > > make menuconfig, still not obvious to me how to disable > > DEBUG_INFO_BTF_MODULES > > I think CONFIG_DEBUG_INFO_BTF_MODULES=n should work fine, but see > above, I don't think the BTF is a problem here, it's not stripping out > DWARF. > > > > > [0] https://lore.kernel.org/bpf/CAKH8qBu0ptKbMVvoMpgN2tyk84ZGvwuCJLjesqw-_8QtSRLqpw@xxxxxxxxxxxxxx/T/#m73cee268387358ec645b665951feb931b294ec2d > > > > Thanks! > >
