Phylink invokes the 'mac_get_pcs_neg_mode' function during interface mode
switching and initial startup.
This function is optional; if 'phylink_pcs_neg_mode' fails to accurately
reflect the current PCS negotiation mode, the MAC driver can determine the
mode based on the interface mode, current link negotiation mode, and
advertising link mode.
For instance, if the interface switches from 2500baseX to SGMII mode,
and the current link mode is MLO_AN_PHY, calling 'phylink_pcs_neg_mode'
would yield PHYLINK_PCS_NEG_OUTBAND. Since the MAC and PCS driver require
PHYLINK_PCS_NEG_INBAND_ENABLED, the 'mac_get_pcs_neg_mode' function
will calculate the mode based on the interface, current link negotiation
mode, and advertising link mode, returning PHYLINK_PCS_NEG_OUTBAND to
enable the PCS to configure the correct settings.
Signed-off-by: Choong Yong Liang <yong.liang.choong@xxxxxxxxxxxxxxx>
---
drivers/net/phy/phylink.c | 14 +++++++++++---
include/linux/phylink.h | 5 +++++
2 files changed, 16 insertions(+), 3 deletions(-)
diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index 38ee2624169c..27aa5d0a9fc6 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -1151,9 +1151,17 @@ static void phylink_major_config(struct phylink *pl, bool restart,
phylink_dbg(pl, "major config %s\n", phy_modes(state->interface));
- pl->pcs_neg_mode = phylink_pcs_neg_mode(pl->cur_link_an_mode,
- state->interface,
- state->advertising);
+ if (pl->mac_ops->mac_get_pcs_neg_mode) {
+ pl->pcs_neg_mode = pl->mac_ops->mac_get_pcs_neg_mode
+ (pl->config,
+ pl->cur_link_an_mode,
+ state->interface,
+ state->advertising);
+ } else {
+ pl->pcs_neg_mode = phylink_pcs_neg_mode(pl->cur_link_an_mode,
+ state->interface,
+ state->advertising);
+ }
if (pl->using_mac_select_pcs) {
pcs = pl->mac_ops->mac_select_pcs(pl->config, state->interface);
diff --git a/include/linux/phylink.h b/include/linux/phylink.h
index b362d3231aa4..adb47d1aa67b 100644
--- a/include/linux/phylink.h
+++ b/include/linux/phylink.h
@@ -169,6 +169,7 @@ void phylink_limit_mac_speed(struct phylink_config *config, u32 max_speed);
* @mac_finish: finish a major reconfiguration of the interface.
* @mac_link_down: take the link down.
* @mac_link_up: allow the link to come up.
+ * @mac_get_pcs_neg_mode: Get PCS negotiation mode for interface mode.
*
* The individual methods are described more fully below.
*/
@@ -189,6 +190,10 @@ struct phylink_mac_ops {
struct phy_device *phy, unsigned int mode,
phy_interface_t interface, int speed, int duplex,
bool tx_pause, bool rx_pause);
+ unsigned int (*mac_get_pcs_neg_mode)(struct phylink_config *config,
+ unsigned int mode,
+ phy_interface_t interface,
+ const unsigned long *advertising);
};
#if 0 /* For kernel-doc purposes only. */
--
2.34.1
