I installed Ubuntu server using the Raspberry Pi imager, then simply worked w/it via SSH. On 7/31/21, Linux for blind general discussion <blinux-list@xxxxxxxxxx> wrote: > Hello, > > I don't know about the older versions of Pi, but I've set up 4B > successfully without any sighted assistance using the official Raspberry > OS image. > > > Pranav Lav wrote a very good tutorial on his blog: > > https://techesoterica.com/getting-the-orca-screen-reader-working-on-a-raspberry-pi-4-with-raspbian-buster-and-the-mate-desktop/ > > > I have tweaked it a bit for my purposes, including configuration of the > language and wifi over SSH, using the default desktop environment (which > is a fork of LXDe) and installing Orca directly from the repository, as > the from source installation did not work very well - I was not able to > confirm the configuration requested on the first run. > > Though I suppose this can be worked around simply by installing > source-compiled Orca over a repository installation, I use it this way > on my laptop and it works quite well (the repository version is not > updated anywhere near low frequently, so I'm not worried about things > getting messed. :) ) > > > Best regards > > > Rastislav > > > Dňa 31. 7. 2021 o 17:41 Linux for blind general discussion napísal(a): >> Hi, >> >> >> >> My Raspberry PI device lost power during an upgrade so wasn't booting any >> longer. I reflashed the SD card to just do a clean install. But I am now >> curious if there is a way to get ORCA or other speech to do setup? >> >> >> >> The first time I did this, I had sighted assistance because I and a >> brother >> were setting up four of these at the same time >> >> >> >> I've tried a few things to try and get things talking with no luck. I'm >> using the default Raspberry PI image from their site. >> >> >> >> Kelly >> >> _______________________________________________ >> Blinux-list mailing list >> Blinux-list@xxxxxxxxxx >> https://listman.redhat.com/mailman/listinfo/blinux-list >> > > > _______________________________________________ > Blinux-list mailing list > Blinux-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/blinux-list -- Subscribe to a WordPress for Newbies Mailing List by sending a message to: wp4newbs-request@xxxxxxxxxxxxx with 'subscribe' in the Subject field OR by visiting the list page at http://www.freelists.org/list/wp4newbs & check out my sites at www.brightstarsweb.com & www.mysitesbeenhacked.com _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://listman.redhat.com/mailman/listinfo/blinux-list