Mp here, Yeah, you're right. I've been through the setup, but have no idea what to set to what. I tried guessing at a few settings, but no luck. Mark Peveto Registered Linux user number 600552 Everything happens after coffee! On Tue, 9 May 2017, Linux for blind general discussion wrote: > This is Kelly. > I seem to recall the transport had a config mode to setup the serial port > correctly... > I think there is a little button on it to do that. > I cannot remember the steps, however. > kp > > > > On Tue, 9 May 2017, Linux for blind general discussion wrote: > > > There is someone I know who might have an idea. will share this post and > > see if they can help you. > > Karen > > > > > > On Tue, 9 May 2017, Linux for blind general discussion wrote: > > > > > I got the serial cord this afternoon. I've connected it to the > > > transport, > > > yet it still reports serial port notready. Not sure how to precede from > > > here, as I'm not able to find documentation. > > > > > > > > > Mark Peveto > > > Registered Linux user number 600552 > > > Everything happens after coffee! > > > > > > _______________________________________________ > > > Blinux-list mailing list > > > Blinux-list@xxxxxxxxxx > > > https://www.redhat.com/mailman/listinfo/blinux-list > > > > > > > > > > _______________________________________________ > > Blinux-list mailing list > > Blinux-list@xxxxxxxxxx > > https://www.redhat.com/mailman/listinfo/blinux-list > > > > > > _______________________________________________ > Blinux-list mailing list > Blinux-list@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/blinux-list > _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list