Kristoffer Gustafsson wrote: > Oh, dear. I'll never sucseed with this. > I've read a guide page, and there was a lot files to edit. I read the > page and almost got a headache. > is there any easier way? There are some high-level programs, like wicd-curses. Otherwise, I can tell you that it's a problem you'll solve once and not have to worry about ever again. Here's a good tutorial, 8 steps, but if the gumball comes out you can be happy! I list the steps below. http://www.blackmoreops.com/2014/09/18/connect-to-wifi-network-from-command-line-in-linux/ The page explains more, but this summary comes at the end. You should probably become root for this, e.g. sudo su. 1. See what your wireless device is: root@kali:~# iw dev 2. Assuming it is wlan0, bring up that interface: root@kali:~# ip link set wlan0 up 3. Look for wireless access point: root@kali:~# iw wlan0 scan 4. Put the access point and passphrase into the config file: root@kali:~# wpa_passphrase blackMOREOps >> /etc/wpa_supplicant.conf 5. Connect to the access point: root@kali:~# wpa_supplicant -i wlan0 -c /etc/wpa_supplicant.conf 6. Check that you are connected: root@kali:~# iw wlan0 link 7. Ask for an IP address (I added the first command, to kill existing dhclient processes). root@kali:~# dhclient -x root@kali:~# dhclient wlan0 8. Check your internet connectivity: root@kali:~# ping 8.8.8.8 9. That is usually enough, but the article provides a command to set a default route. root@kali:~# ip route add default via 10.0.0.138 dev wlan0 I usually just make sure that ethernet interface is turned off: root@kali:~# ifconfig eth0 down Cheers, hope this helps. -- Joel Roth _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list