Hi, Within ecasound, once the chain setup is set up in interactive mode (-c) use start to start processing and stop to stop it. You can then just use start to continue from where you were. If you want to do it in batch mode, you will have to make sure that you put the possision to the end of the output file before you start processing so as to append to the file. HTH, Willem On Sat, 26 May 2007, Jan and Bertil Smark Nilsson wrote: > Greetings, > > I'm using Ecasound in iteractive mode to record from my soundcard. Is there a > way to pause the recording and then start it again recording to the same file? > I've been studying the literature, but without success. > > Bertil Smark Nilsson > > _______________________________________________ > Blinux-list mailing list > Blinux-list@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/blinux-list > > -- This message is subject to the CSIR's copyright, terms and conditions and e-mail legal notice. Views expressed herein do not necessarily represent the views of the CSIR. CSIR E-mail Legal Notice http://mail.csir.co.za/CSIR_eMail_Legal_Notice.html CSIR Copyright, Terms and Conditions http://mail.csir.co.za/CSIR_Copyright.html For electronic copies of the CSIR Copyright, Terms and Conditions and the CSIR Legal Notice send a blank message with REQUEST LEGAL in the subject line to CallCentre@xxxxxxxxxxx This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. MailScanner thanks Transtec Computers for their support. _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list