Hello, i have tryedto start brllty again. insmod usbcore insmod usb-uhci brltty -f /etc/brltty-vo-35.conf (i have created a config for the vo) And brltty runs. But only if the voyager ist connected directly to usb. If i connect the braille display via the "plux-box", so that i can can select, that the voyager works as combibraille, which is connect to a serial port or as voyager via usb (the plus-box is connect to usb and a serial port). for a good year i have become a patch for an brlvger-module for the 2.2.25 kernel. This kernel (2.2.25) works with brltty 3.4.x direct with the plus- box, so i can run brltty two times brlltty -b cb and brltty -b vo and switch between a key-combination of the brailledisplay-keys. But that did noc work with kernel 2.4.20. Regards. Dietmar > [quoted lines by Krister Ekstrom on 2004/04/04 at 12:10 +0200] > > >Try the following: > >brltty -bvo -dusb: > >The colon is important for some reason. > > Yes, the colon is important. Without it, brltty will think you mean _______________________________________________ Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list