On 02/27/2018 12:49 AM, KAVITA MATHUR wrote:
Hi, I have configured AP in g mode and tested legacy rates.All basic rates and supported rates(1,2,5.5,11,6,9,12,18,24,36,48,54) are set except 9Mbps. When fixed bit rate 9Mbps is set, it gets set as 24 Mbps. This issue has been observed in backports-4.4.2-1 as well as latest git version of ath10k driver. Is anybody aware of this issue? How can I fix this rate 9Mbps?
You should specify which firmware/chipset you are using, since this might easily be a firmware issue. And, how are you determining that 'it gets set to 24Mbps'. Is that the encoding you see in a wifi sniff, or is the driver being set to 24Mbps improperly when you use iw (or whatever) to try configuring the rate? Recent upstream mac80211 has broken the ability to set a single tx rate as well, last I checked. Thanks, Ben
Thanks & Regards, Kavita -- To unsubscribe from this list: send the line "unsubscribe backports" in
-- Ben Greear <greearb@xxxxxxxxxxxxxxx> Candela Technologies Inc http://www.candelatech.com -- To unsubscribe from this list: send the line "unsubscribe backports" in
