Hi all,
I would create a Guppy 7.0.2 image for H3 + Kingfisher.
I followed the guide:
https://docs.iot.bzh/docs/en/master/getting_started/reference/getting-started/machines/renesas.html
https://docs.iot.bzh/docs/en/master/getting_started/reference/getting-started/machines/renesas.html
As described in the guide, before flashing the SD card I must update the firmware so I followed
My board is RTP0RC77951SKBX010SA03 but I haven't the files described in the table (i.e. bootparam_sa0-4x2g.srec)
So reading the "Appendinx" I set H3_OPTION_forcevariable = "1" in the conf/local.conf file and compile again lauching:
- bitbake -c cleanall agl-demo-platform
- bitbake -k agl-demo-platform
- bitbake -c cleanall arm-trusted-firmware u-boot
- bitbake -k arm-trusted-firmware u-boot
- bitbake -k -f virtual/kernel
but the files that I need aren't been created.
What can I do?
Thank you.
Regards,
Francesco
_______________________________________________ automotive-discussions mailing list automotive-discussions@xxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linuxfoundation.org/mailman/listinfo/automotive-discussions
