Eric Bentley <eric.bentley@xxxxxxxxxxxxx> wrote: > The ath6kl driver attempts to get the txpower value from the radio by first > clearing the existing stored value and then watching the value to become > non-zero. > > APs allow setting client power to values from -127..127, but this radio > is not capable of setting values less then 0 and so will report txpower > as 0dbm for both negative and 0 client power values. > > When the radio has txpower set to 0dbm txpower (equivalent to 1mw) the > ath6kl_cfg80211_get_txpower() function will remain in the > wait_event_interruptible_timeout() loop waiting for the value to be > non-zero, and will eventually timeout. This results in a 5 second delay in > response. However, the correct value of zero is eventually returned. > > The 6004 defaults to 63dbm which is then limited by regulatory and > hardware limits with max of 18dbm (6003 max is 16dbm), therefore we can > use values larger then these to be able to determine when the value has > been updated. > > To correct the issue, set the value to a nonsensical value (255) and wait > for it to change to the valid value. Thanks, 1 patch applied to ath-next branch of ath.git: cabd34d0e9c4 ath6kl: Allow the radio to report 0 dbm txpower without timing out -- Sent by pwcli https://patchwork.kernel.org/patch/9304907/ _______________________________________________ ath6kl mailing list ath6kl@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/ath6kl
