Hi Nick, Did you have some success with this? Looking to do the same here too. Cheers, Attila On Wed, Dec 17, 2014 at 8:52 PM, Stevens, Nick <Nick.Stevens@xxxxxxxxxxxx> wrote: > Hi all, > > I am attempting to use an AR6003 in a concurrent AP/station mode. Using the iw tool to try and add a second virtual interface gives me the following error: > > iw phy phy0 interface add wlan0_ap type __ap > ath6kl: Not a supported interface type > > I get the same thing for "managed" and "station" types. > > I've traced the error back into the kernel to a check against available VIFs. It seems that the driver is being loaded with "1" for the max_vif's, which is strange since I know this device supports AP+STA. > > In short - can anyone provide any information about putting the AR6003 into concurrent AP+STA mode? Is this even possible with the in-kernel firmware and driver? > > Nick Stevens > > > > > _______________________________________________ > ath6kl mailing list > ath6kl@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/ath6kl -- Attila Sukosd CTO & Co-founder +45 27 14 88 03 attila@xxxxxxxxxxx LinkedIn GitHub ________________________________ AIRTAME ApS Vestergade 20C, 2nd Floor 1456 Copenhagen Denmark airtame.com Facebook LinkedIn Twitter _______________________________________________ ath6kl mailing list ath6kl@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/ath6kl
