|
Hello, I was doing a bit of experimenting with dmraid. What I have done
is to create a raid0+1 array, and then physically pull one of the disks out. I
then use the command “dmraid –n” to look at the metadata on
the member disks. I notice that the member disk listed by the output that has
the specific serial number of the disk that I pulled, whose status I expect to
be different from the other disks listed, still has the same status as the
other still physically plugged in. (i.e disk[0].status: 0x53a is shown for all
of the disks, even the one that I pulled out). Is this normal? The following is the output of “dmraid –V”: dmraid version: 1.0.0.rc16 (2009.09.16) shared dmraid library version: 1.0.0.rc16 (2009.09.16) device-mapper version: 4.13.0 Thanks for clarifying, Sandra |
_______________________________________________ Ataraid-list mailing list Ataraid-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/ataraid-list
