I'm trying to install Red Hat Enterprise 3.1 on a machine with a FastTrak Lite TX2000 in RAID1 mode, but I'm beginning to think it's not going to be possible... I can install the OS if the card is in disk-spanning (JBOD) mode, so I first did a vanilla install and use that to compile the promise driver for the Red Hat boot kernel. I can now switch the card to RAID1 and run the Red Hat installation OK by loading the FastTrak driver manually at the start of the install process (if I don't do this, it says it can't see any valid storage device and aborts the install). Now, however, I'm trying to work out how to boot into the installation. I can boot using Red Hat rescue mode off the CD to edit grub.conf and give it what I think is the necessary kernel parameters (as per the ATA RAID HOWTO). The installation boots, but can't mount any of the partitions. If I log in and do a df I can see everything mounted on /dev/hdg2. If I do an lsmod, the FastTrak driver isn't running. I can load it manually, and it appears to go in without errors, but I can't see the array. Can anyone give me any clues? I can't upgrade the kernel, because I'm in a chicken-and-egg situation with that. Jonathan
