Re: Lost Interrupt, agian (on HPT370)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Thx, agian I'll try it when i get home.
Btw. how do i set the lilo boot option: nousb ?

-Lau
 
> Hi,
> Try: enable PCI IRQ sharing in kernel, PCI Bus mastering in 
Kernel, Use
> DMA when enable feature in kernel and disable the following in 
BIOS if you
> can:
> IRQ for VGA  
> IRQ for modem
> IRQ for USB
> lilo boot option: nousb
> 
>  On 27 Apr 2002, Lau Bech Lauritzen wrote:
> 
> > Hey
> > I really need help.
> > I've been all over the internet looking for at solution to 
my problem.
> > I've also seen a lot of people with the same problem, but 
nothing has
> > helped yet.
> > 
> > My problem is that i get a large amount of "hgx: lost 
interrupt" at
> > start up on the disks on my HPT370 controller.
> > 
> > Here's a little info:
> > I'm running Debian with 2.4.19 pre6 kernel
> > Tryed BIOS version 2.2 and 2.31
> > Tryed 2x60GB IBM 60GXP
> > Tryed 2x60GB Mator 
> > Using High Points own 1.3 driver (hpt37x2.o)
> > hpt37x2.o is in /lib/modules/2.4.19-pre6/
> > The module has also been added to /etc/modules
> > 
> > [/] lsmod
> > Module                  Size  Used by    Tainted: P  
> > NVdriver              941728  10  (autoclean)
> > hpt37x2                57248   0
> > 
> > Everything works fine (the array has been parted), but mig 
boot time is
> > about 5 min. and that's quite a draw back!
> > 
> > Please help...
> > 
> > -Lau
> > 
> > PS: here's the dmesg
> > 
> > VP_IDE: IDE controller on PCI bus 00 dev 21
> > VP_IDE: detected chipset, but driver not compiled in!
> > VP_IDE: chipset revision 16
> > VP_IDE: not 100% native mode: will probe irqs later
> >     ide1: BM-DMA at 0xd800-0xd807, BIOS settings: hdc:DMA, 
hdd:DMA
> >     ide2: BM-DMA at 0xd808-0xd80f, BIOS settings: hde:pio, 
hdf:pio
> > HPT372: IDE controller on PCI bus 00 dev 50
> > HPT372: detected chipset, but driver not compiled in!
> > PCI: Found IRQ 9 for device 00:0a.0
> > HPT372: chipset revision 5
> > HPT372: not 100% native mode: will probe irqs later
> >     ide3: BM-DMA at 0x9000-0x9007, BIOS settings: hdg:pio, 
hdh:pio
> >     ide4: BM-DMA at 0x9008-0x900f, BIOS settings: hdi:pio, 
hdj:pio
> > PDC20265: IDE controller on PCI bus 00 dev 88
> > PCI: Found IRQ 10 for device 00:11.0
> > PCI: Sharing IRQ 10 with 00:0b.0
> > PDC20265: chipset revision 2
> > PDC20265: not 100% native mode: will probe irqs later
> > PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode 
Secondary PCI Mode.
> >     ide0: BM-DMA at 0x6400-0x6407, BIOS settings: hda:pio, 
hdb:pio
> >     ide5: BM-DMA at 0x6408-0x640f, BIOS settings: hdk:pio, 
hdl:DMA
> > hda: IC35L060AVER07-0, ATA DISK drive
> > hdc: ASUS CD-S400/A, ATAPI CD/DVD-ROM drive
> > hdd: PLEXTOR CD-R PX-W1210A, ATAPI CD/DVD-ROM drive
> > hdg: MAXTOR 6L060J3, ATA DISK drive
> > hdi: MAXTOR 6L060J3, ATA DISK drive
> > hdk: IC35L040AVER07-0, ATA DISK drive
> > hdl: IC35L040AVER07-0, ATA DISK drive
> > ide0 at 0x7800-0x7807,0x7402 on irq 10
> > ide1 at 0x1f0-0x1f7,0x3f6 on irq 14
> > ide3 at 0xa400-0xa407,0xa002 on irq 9
> > ide4 at 0x9800-0x9807,0x9402 on irq 9
> > ide5 at 0x7000-0x7007,0x6802 on irq 10
> > hda: 120103200 sectors (61493 MB) w/1916KiB Cache, 
CHS=119150/16/63,
> > UDMA(100)
> > hdg: lost interrupt
> > hdg: lost interrupt
> > hdg: lost interrupt
> > hdg: 117266688 sectors (60041 MB) w/1819KiB Cache, 
CHS=116336/16/63
> > hdg: lost interrupt
> > hdg: lost interrupt
> > hdi: lost interrupt
> > hdi: lost interrupt
> > hdi: lost interrupt
> > hdi: 117266688 sectors (60041 MB) w/1819KiB Cache, 
CHS=116336/16/63
> > hdi: lost interrupt
> > hdi: lost interrupt
> > hdk: 80418240 sectors (41174 MB) w/1916KiB Cache, 
CHS=79780/16/63,
> > UDMA(100)
> > hdl: 80418240 sectors (41174 MB) w/1916KiB Cache, 
CHS=79780/16/63,
> > UDMA(100)
> > hdc: ATAPI 40X CD-ROM drive, 128kB Cache
> > Uniform CD-ROM driver Revision: 3.12
> > Partition check:
> >  hda: [PTBL] [7476/255/63] hda1 hda2 hda3 hda4 < hda5 >
> >  hdg:hdg: lost interrupt
> >  [PTBL] [7299/255/63] hdg1 hdg2 hdg3 <hdg: lost interrupt
> >  >
> >  hdi:hdi: lost interrupt
> >  unknown partition table
> >  hdk: [PTBL] [5005/255/63] hdk1 < hdk5 >
> >  hdl: [PTBL] [5005/255/63] hdl1 < hdl5 >
> > 
> > 
> > 
> > 
> > _______________________________________________
> > 
> > Ataraid-list@xxxxxxxxxx
> > https://listman.redhat.com/mailman/listinfo/ataraid-list
> > 
> 
> 
> 
> _______________________________________________
> 
> Ataraid-list@xxxxxxxxxx
> https://listman.redhat.com/mailman/listinfo/ataraid-list
> 





[Index of Archives]     [Linux RAID]     [Linux Device Mapper]     [Linux IDE]     [Linux SCSI]     [Kernel]     [Linux Books]     [Linux Admin]     [GFS]     [RPM]     [Yosemite Campgrounds]     [AMD 64]

  Powered by Linux