Well, at the moment I'm useing the 2.4.19-pre6 kernel, is there a huge difference between these 2 kernels? -Lau > 2.4.18 stock was giving me huge problems on my Fasttrak TX4. Upgrading to > 2.4.19-pre7 changed the Promise chip ID message from 20268 to 20270, and > completely solved all issues I was having. No long startup delays, no lost > interrupt, just pure multi-OS RAID bliss. > > - Forge > > On Saturday 27 April 2002 08:20 am, you wrote: > > I had the same problem. > > I simply had to change the PCI-Slot for the HPT370 Controller card.. > > Now everything works perfect > > > > > > -----Ursprüngliche Nachricht----- > > Von: ataraid-list-admin@xxxxxxxxxx > > [mailto:ataraid-list-admin@xxxxxxxxxx] Im Auftrag von Lau Bech Lauritzen > > Gesendet: Samstag, 27. April 2002 03:01 > > An: ataraid-list@xxxxxxxxxx > > Betreff: Lost Interrupt, agian (on HPT370) > > > > Hey > > I really need help. > > I've been all over the internet looking for at solution to my problem. > > I've also seen a lot of people with the same problem, but nothing has > > helped yet. > > > > My problem is that i get a large amount of "hgx: lost interrupt" at > > start up on the disks on my HPT370 controller. > > > > Here's a little info: > > I'm running Debian with 2.4.19 pre6 kernel > > Tryed BIOS version 2.2 and 2.31 > > Tryed 2x60GB IBM 60GXP > > Tryed 2x60GB Mator > > Using High Points own 1.3 driver (hpt37x2.o) > > hpt37x2.o is in /lib/modules/2.4.19-pre6/ > > The module has also been added to /etc/modules > > > > [/] lsmod > > Module Size Used by Tainted: P > > NVdriver 941728 10 (autoclean) > > hpt37x2 57248 0 > > > > Everything works fine (the array has been parted), but mig boot time is > > about 5 min. and that's quite a draw back! > > > > Please help... > > > > -Lau > > > > PS: here's the dmesg > > > > VP_IDE: IDE controller on PCI bus 00 dev 21 > > VP_IDE: detected chipset, but driver not compiled in! > > VP_IDE: chipset revision 16 > > VP_IDE: not 100% native mode: will probe irqs later > > ide1: BM-DMA at 0xd800-0xd807, BIOS settings: hdc:DMA, hdd:DMA > > ide2: BM-DMA at 0xd808-0xd80f, BIOS settings: hde:pio, hdf:pio > > HPT372: IDE controller on PCI bus 00 dev 50 > > HPT372: detected chipset, but driver not compiled in! > > PCI: Found IRQ 9 for device 00:0a.0 > > HPT372: chipset revision 5 > > HPT372: not 100% native mode: will probe irqs later > > ide3: BM-DMA at 0x9000-0x9007, BIOS settings: hdg:pio, hdh:pio > > ide4: BM-DMA at 0x9008-0x900f, BIOS settings: hdi:pio, hdj:pio > > PDC20265: IDE controller on PCI bus 00 dev 88 > > PCI: Found IRQ 10 for device 00:11.0 > > PCI: Sharing IRQ 10 with 00:0b.0 > > PDC20265: chipset revision 2 > > PDC20265: not 100% native mode: will probe irqs later > > PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode. > > ide0: BM-DMA at 0x6400-0x6407, BIOS settings: hda:pio, hdb:pio > > ide5: BM-DMA at 0x6408-0x640f, BIOS settings: hdk:pio, hdl:DMA > > hda: IC35L060AVER07-0, ATA DISK drive > > hdc: ASUS CD-S400/A, ATAPI CD/DVD-ROM drive > > hdd: PLEXTOR CD-R PX-W1210A, ATAPI CD/DVD-ROM drive > > hdg: MAXTOR 6L060J3, ATA DISK drive > > hdi: MAXTOR 6L060J3, ATA DISK drive > > hdk: IC35L040AVER07-0, ATA DISK drive > > hdl: IC35L040AVER07-0, ATA DISK drive > > ide0 at 0x7800-0x7807,0x7402 on irq 10 > > ide1 at 0x1f0-0x1f7,0x3f6 on irq 14 > > ide3 at 0xa400-0xa407,0xa002 on irq 9 > > ide4 at 0x9800-0x9807,0x9402 on irq 9 > > ide5 at 0x7000-0x7007,0x6802 on irq 10 > > hda: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, > > UDMA(100) > > hdg: lost interrupt > > hdg: lost interrupt > > hdg: lost interrupt > > hdg: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 > > hdg: lost interrupt > > hdg: lost interrupt > > hdi: lost interrupt > > hdi: lost interrupt > > hdi: lost interrupt > > hdi: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 > > hdi: lost interrupt > > hdi: lost interrupt > > hdk: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, > > UDMA(100) > > hdl: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, > > UDMA(100) > > hdc: ATAPI 40X CD-ROM drive, 128kB Cache > > Uniform CD-ROM driver Revision: 3.12 > > Partition check: > > hda: [PTBL] [7476/255/63] hda1 hda2 hda3 hda4 < hda5 > > > hdg:hdg: lost interrupt > > [PTBL] [7299/255/63] hdg1 hdg2 hdg3 <hdg: lost interrupt > > > > hdi:hdi: lost interrupt > > unknown partition table > > hdk: [PTBL] [5005/255/63] hdk1 < hdk5 > > > hdl: [PTBL] [5005/255/63] hdl1 < hdl5 > > > > > > > > > > > _______________________________________________ > > > > Ataraid-list@xxxxxxxxxx > > https://listman.redhat.com/mailman/listinfo/ataraid-list > > > > > > > > > > > > _______________________________________________ > > > > Ataraid-list@xxxxxxxxxx > > https://listman.redhat.com/mailman/listinfo/ataraid-list > > > > _______________________________________________ > > Ataraid-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/ataraid-list >
