Hi,
I'm trying to get a on-board PDC20265r "raid" controller to work with the
ataraid driver... Unfortunately I had no luck yet...
The problem seems to be that the disks of the raid-1 array are detected as
hde and hdg.
Next the promise fastrak driver tells me that "No raid array found", which
is strange because I rebuild the whole array and the controller says there
is one.
During Kernel compilation I selected CONFIG_BLK_DEV_PDC202XX,
CONFIG_PDC202XX_BURST, CONFIG_PDC202XX_FORCE, CONFIG_BLK_DEV_ATARAID,
CONFIG_BLK_DEV_ATARAID_PDC and CONFIG_BLK_DEV_ATARAID_HPT
thanks for any advice,
andreas
The Kernel messages are the following:
Aug 30 13:14:29 dyn119 kernel: PDC20265: IDE controller on PCI bus 00 dev 80
Aug 30 13:14:29 dyn119 kernel: PCI: Found IRQ 11 for device 00:10.0
Aug 30 13:14:29 dyn119 kernel: PDC20265: chipset revision 2
Aug 30 13:14:29 dyn119 kernel: ide: Found promise 20265 in RAID mode.
Aug 30 13:14:29 dyn119 kernel: PDC20265: not 100%% native mode: will probe irqs later
Aug 30 13:14:29 dyn119 kernel: PDC20265: ROM enabled at 0xdffd0000
Aug 30 13:14:29 dyn119 kernel: PDC20265: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
Aug 30 13:14:29 dyn119 kernel: ide2: BM-DMA at 0xcc00-0xcc07, BIOS settings: hde:pio, hdf:pio
Aug 30 13:14:29 dyn119 kernel: ide3: BM-DMA at 0xcc08-0xcc0f, BIOS settings: hdg:pio, hdh:pio
Aug 30 13:14:29 dyn119 kernel: hda: IC35L040AVER07-0, ATA DISK drive
Aug 30 13:14:29 dyn119 kernel: hdc: SR243T, ATAPI CD/DVD-ROM drive
Aug 30 13:14:29 dyn119 kernel: hde: IC35L040AVER07-0, ATA DISK drive
Aug 30 13:14:29 dyn119 kernel: hdg: IC35L040AVER07-0, ATA DISK drive
Aug 30 13:14:29 dyn119 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Aug 30 13:14:29 dyn119 kernel: ide1 at 0x170-0x177,0x376 on irq 15
Aug 30 13:14:29 dyn119 kernel: ide2 at 0xdc00-0xdc07,0xd802 on irq 11
Aug 30 13:14:29 dyn119 kernel: ide3 at 0xd400-0xd407,0xd002 on irq 11
Aug 30 13:14:29 dyn119 kernel: hda: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=5005/255/63, UDMA(33)
Aug 30 13:14:29 dyn119 kernel: hde: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, UDMA(100)
Aug 30 13:14:29 dyn119 kernel: hdg: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, UDMA(100)
Aug 30 13:14:29 dyn119 kernel: ide-floppy driver 0.97
Aug 30 13:14:29 dyn119 kernel: Partition check:
Aug 30 13:14:29 dyn119 kernel: hda: hda1 hda2 hda3
Aug 30 13:14:29 dyn119 kernel: hde:
Aug 30 13:14:29 dyn119 kernel: hdg:
Aug 30 13:14:29 dyn119 kernel: Floppy drive(s): fd0 is 1.44M
Aug 30 13:14:29 dyn119 kernel: FDC 0 is a post-1991 82077
Aug 30 13:14:29 dyn119 kernel: ide-floppy driver 0.97
Aug 30 13:14:29 dyn119 kernel: Promise Fasttrak(tm) Softwareraid driver for linux version 0.02
Aug 30 13:14:29 dyn119 kernel: No raid array found
Aug 30 13:14:29 dyn119 kernel: Highpoint HPT370 Softwareraid driver for linux version 0.01
Aug 30 13:14:29 dyn119 kernel: No raid array found
lspci -v gives the following information about the promise chipset:
00:10.0 RAID bus controller: Promise Technology, Inc. 20265 (rev 02)
Subsystem: Promise Technology, Inc.: Unknown device 4d39
Flags: bus master, medium devsel, latency 64, IRQ 11
I/O ports at dc00 [size=8]
I/O ports at d800 [size=4]
I/O ports at d400 [size=8]
I/O ports at d000 [size=4]
I/O ports at cc00 [size=64]
Memory at dffe0000 (32-bit, non-prefetchable) [size=128K]
Expansion ROM at dffd0000 [disabled] [size=64K]
Capabilities: [58] Power Management version 1
