On Thu, 26 Jul 2012 12:54:58 -0300, Gustavo M?rsico <gustavomarsico at gmail.com> wrote: > I faced a similar issue recently and was related to the Screening > Indicator. Was solved adding before Dial the following line: > > Set(CALLERPRES()=allowed) or Set(CALLERPRES()= prohib) > > In both cases the important was the 2 bits saying "network provided". > > Hope this helps. > > > On Jul 26, 2012, at 12:29 PM, Marcus Vinicius wrote: > >> Hi Kaloyan, >> >> If I change ss7type=ansi the link doens't work: >> >> [Jul 26 11:05:43] ERROR[637]: chan_dahdi.c:13836 dahdi_ss7_error: [3] >> Received message destined for point code 0x37c372 but we're 0x372. >> Dropping >> >> The ERICSSON uses ITU standard as well. It uses ITU/ISUP BRAZIL. >> >> But the Ericsson doesn't understand the F on the number. Not sure about the Brazil variant, but ITU-T Q.764 defines the en-block dialing to end with ST. 0xf is ST signal it means 'end of dialing' or 'number is complete', so it should understand it and your problem is probably somewhere else. As Johann Steinwendtner have noted you receive the number without leading 0, but you send it with 0 - this or as Gustavo suggested Screening/Presentation may be the problem. >> > >> > Can I disable this F ? >> > >> > Is it hardcode? Anyone knows how can I change this? >> > Yes, it is hardcoded for ITU switchtype - check isup.c isup_set_called(). You may try to modify the code, but i don't think that this is the problem. >> > >> > Thank you so much! >> > >> > >> > -- >> > Marcus Vinicius >> >> >> -- >> _____________________________________________________________________ >> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >> >> asterisk-ss7 mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-ss7
|