Hi, thanks for your replies. I ?ll try your suggestions. The reason I have differents adjpointcode and defaultdpc is that my carrier has a config of non associated ss7, which means that signalling goes exclusively to one node/switch and the voice is carried to a different node/switch. I was wondering if I should set up two different channels in my chan_dahdi.conf for each carrier?s switch? [channels] #First channel signalling only language=en ... sigchan=16 adjpointcode = 8122-> signalling node defaultdpc = 8122 -> signalling node #Second channel voice only language=en ... adjpointcode = 8845 -> voice node defaultdpc = 8845 -> voice node channel= 1-15 channel= 17-31 Have you seen this carrier setting before? Thanks,regards Hern?n Apr 22, 2012 07:59:02 AM, asterisk-ss7 at lists.digium.com wrote: =========================================== Try putting sane point code in the adpointcode as defaultdpc On Apr 20, 2012 7:16 PM, "her Garcia" wrote: Hi, everyone. I am working on asterisk+ss7. When I try to make a call, the call connects but I have no audio or see no progress in the debug. ? ? -- Executing [111536972876 at incoming:2] Dial("SIP/1153640000-00000005", "DAHDI/17") in new stack ? ?-- Executing [111536972876 at incoming:2] Dial("SIP/1153640000-00000005", "DAHDI/17") in new stack host*CLI> ? ? -- Called DAHDI/17 ? ?-- Called DAHDI/17 Nothing else. I believe it should also include the following: >> ? ? -- DAHDI/1-1 is proceeding passing it to SIP/600-08887770 --- ?I don?t get this >> ? ? -- DAHDI/1-1 is ringing >> ? ? -- DAHDI/1-1 answered SIP/600-08887770 My linkset is up, my channels are ok. My carrier tells me that he doesn?t see any calls reaching his node. I believe it?s because the call doesn?t progress. This is my config The carrier says that his ss7 is semi-associated. Divides signalling in one node and voice trunks/circuits in a second node. I only have the following to configure adjpointcode=8122 defaultdpc=8845 I know defaultdpc is the remote end. Signalling is ok verified by my carrier, so I think my adjpointcode is ok. The thing is that I also get messages from a third node in my debug, number "8923" saying the following: ?WARNING[18934]: sig_ss7.c:392 ss7_find_cic_gripe: Linkset 1: SS7 RLC requested unconfigured CIC/DPC 14/8923. I understand its about the circuits. I tried configuring that node as my adjpointcode, but I can?t get through, it maybe something on the Carrier side for this particular node(8923) I have been working this for a couple of weeks, any ideas? Thanks, I apologize for this long post. Hern?n -- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-ss7 mailing list To UNSUBSCRIBE or update options visit: ? http://lists.digium.com/mailman/listinfo/asterisk-ss7 -- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-ss7 mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-ss7