Hi Jacub! Thanks for the patch! It's usefull! I've a littile question, will the patch work with different opc's? on different linksets? I mean If I'm connected with 2x telcos and for both of them I should have different opc? If no, seems you understand chan_ss7 internals quite good, maybe you will not find it very difficult to add such a functionality? Regards, Anton. On 5 December 2006 00:32, Jakub Klausa wrote: > Hello, > > here's another patch we, at ss7.pl wrote for chan_ss7 > 0.9. > > AutoPC, or Auto Point Code patch, gives you the ability > to ommit the opc/dpc configuration entirely, and refain > the point code addresses from the link (if it's > configured right at the other end - as an exercise, try > to link asterisks with AutoPC on on both ends of a link > ;)). > > All you need to do, is to add: > > [19:57:04] [70] manhattan:jacke:~> tail ss7.conf > > [host-manhattan] > enabled => yes > autopc => yes > ;opc => 0x1111 > ;dpc => test:0x2222 > links => l1:1,l2:2 > > The 'autopc => yes' directive allows you not to specify > any opc and dcp parameters. If you include them, they're > ignored anyway. > > After starting asterisk, you'll get something like this: > > [chan_ss7.so] => (SS7 Protocol Support) > [...] > Dec 4 19:16:13 NOTICE[26879]: config.c:860 load_config: > Configuring DPC 0 for linkset 'test'. [...] > -- SS7 channel loaded successfully. > Dec 4 19:16:23 WARNING[26902]: mtp.c:822 > timeout_sltm_t1: No SLTA received within Q.707 timer T1, > trying again on link 'l1'. Dec 4 19:16:23 NOTICE[26901]: > mtp.c:1195 mtp2_good_frame: autopc = 1 Dec 4 19:16:23 > WARNING[26902]: chan_ss7.c:651 monitor_main: MTP is now > UP on link 'l1'. Dec 4 19:16:23 WARNING[26902]: > chan_ss7.c:661 monitor_main: MTP is now INSERVICE for > linkset 'test'. *CLI> ss7 show links > Number of linksets: 1. > Linkset 1 name is: test. > Number of links in linkset: 2. > Link number 1 name is: l1 > Link number 2 name is: l2 > Config opc=0x1111, dpc=0x2222 > > The warning is fine, as understandably we have to sit > silet and wait for the other side to send us something, > so we can guess the point codes. > > As you see - the command 'ss7 show links' will show you > the opc and dpc parameters being used. > > The patch can be found at: > > http://www.ss7.pl/~jacke/patches/chan_ss7/chan_ss7-0.9.p >atch-2.gz > > (in the combined form, with the previous chan_ss7 0.9 > patch by ss7.pl) > > If you have any questions - drop me a note.
|