Re: Realtek 8111/8168/8411 Blues - cannot get dhcpcd address (link UP)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



On 08/20/2015 05:56 PM, Anatol Pomozov wrote:
Check this threadhttps://bbs.archlinux.org/viewtopic.php?id=200514  is
it what you see?

What happens if you downgrade to dhcpcd-6.9.0 ?

I will check, but there is something not right going on. I did manage to get an inet address assigned by dhcpcd (for a minute) when I rebooted to box, pulled the CD out, let it boot to the point of "Install System Disk and Press Any Key", put the CD back in, and booted non UEFI mode.

I was going to just assign a static address, but checked 'ifconfig' before disabling dhcpcd and BINGO there was a proper IPv4 address handed out by my dhcpd server (it handed out .166 which was correct, because it handed the broken box .165 an hour before)

However, by the time I went to ping anything, or start sshd so I could ssh into the box, the connection went dead again (meaning 'ip link' still shows Status UP; if config still shows correct IP address, but any attempt to ping results in: network not found...)

I'll read the thread and let you know if I found a solution. Any other thoughts, just let me know.

--
David C. Rankin, J.D.,P.E.


[Index of Archives]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Share Photos]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]
  Powered by Linux