Re: truecrypt, loop and /etc/modules-load.d/truecrypt.conf

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



On Mon, Oct 14, 2013 at 09:39:56AM -0700, John Davis wrote:
> Hello
> 
> I used the wikipage to address the problem where loop module does not load.
> 
> <snip>
>
>  # tee /etc/modules-load.d/truecrypt.conf <<< "loop"
> 
> {{Note|As of udev 181-5, the loop device module is no longer auto-loaded,
> and the procedure described here is necessary.}}
> 
> 
> I am using a stock kernel.  I tried to use sudo to run truecrypt and it
> failed to setup a loop device.  I did a check of lsmod output and loop was
> not loaded after I made the truecrypt.conf change.
> 
> After I modprobe loop by hand truecrypt would work and the encrypted drive
> would be mounted on /mnt/truecrypt1.  Is there something which needs to
> edited to the wiki page regarding truecrypt.conf?  It does not seem to
> work, and it seems that manually loading the module is required.
> 
> -- 
> John F. Davis
> 6 Kandes Court
> Durham, NC 27713
> 919-888-8358
> 

This change only affects the system on boot. modules-load.d is searched
upon boot and all modules listed are loaded. Have you tried rebooting
after creating the truecrypt.conf file?

--Sean


[Index of Archives]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Share Photos]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]
  Powered by Linux