On 08/25/2012 10:47 PM, rafael ff1 wrote:
2012/8/25 Randy <gumper1034@xxxxxxxxx>:
Hello,
Is anyone here using "stapler-git" from the AUR? I'm trying to use it to
combine two pdf files into one and it's not working for me.
When using the command "stapler cat 1.pdf 2.pdf output.pdf" it just returns
the message "error".
Could someone try this to see if it works ok?
Thanks
Tried, but couldm't reproduce your error. Any error message differente
than 'error'? I suggest contacting the maintainer, in this package's
comments.
p.s.: fyi, issues related to AUR packages should be sent to
aur-general, instead of arch-general.
Rafael
Actually I think I just figured it out. If I try the same command on two
other PDFs then it works just fine. I think there's an issue with one of
the PDFs that it's not 100% Adobe pdf compliant. When I try to convert
the same bad file using ghostscript it works but it tells me the following:
**** Warning: File has an invalid xref entry: 2. Rebuilding xref table.
**** Warning: stream operator isn't terminated by valid EOL.
**** Warning: stream operator isn't terminated by valid EOL.
**** Warning: stream operator isn't terminated by valid EOL.
**** Warning: stream operator isn't terminated by valid EOL.
**** Warning: stream operator isn't terminated by valid EOL.
**** Warning: stream operator isn't terminated by valid EOL.
**** This file had errors that were repaired or ignored.
**** The file was produced by:
**** >>>> <<<<
**** Please notify the author of the software that produced this
**** file that it does not conform to Adobe's published PDF
**** specification.
Thanks for taking the time to help!
Randy
