Re: starting network:fail[eth0 wasn't connected] How to enable without reboot?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



On Tue, May 18, 2010 at 1:45 PM, Joe(theWordy)Philbrook <jtwdyp@xxxxxxxx> wrote:
>
> Currently my pc is a laptop. I don't use a wireless interface. I
> connect to the Internet via cable broadband with a wired Ethernet
> connection and DHCP... This id very reliable. I can usually disconnect
> the laptop from the Ethernet cable and bring it into the livingroom
> for various offline use. Then when I bring it back to my desk, all I
> usually have to to is plug the Ethernet cable back in and wait a few
> seconds and the Internet will start to work again.
>
> BUT that is contingent on the Ethernet cable having been connected
> during boot up. So if for example I were to boot up my laptop in the
> livingroom where there isn't an Ethernet connection the boot process
> will delay at the point where it's screen message says its starting
> the network. Then it says it failed and continues setting everything
> else up.
>
> At this point, if I bring the laptop back to the desk, and plug in the
> Ethernet cable, it doesn't automatically connect. I tried:
>
> # ifconfig eth0 up
>
> but ping still doesn't find my ISP
>
> What am I missing????

Your dhcp process didn't start either, so you need to start one of
those. Something as simple as `dhcpcd -i eth0` might work.

-Dan


[Index of Archives]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Share Photos]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]
  Powered by Linux