i know that you can check that you have something coming in by typing your Interweb IP Address and if something comes up (usually a Config page.) then you have a foot In the door. i Know that Qwest and SpeakEasy do this. On 11/26/06, dan page <danmanfu@xxxxxxxxxxxxxx> wrote:
Morgan Gangwere wrote: > use IP Masquerading, thats what *:80 does. its just you can have > different requests come In to different places. you can also have eth0 > + eth1 have the same IP. that might help. look in your DSL box's > settings > > On 11/26/06, Steve Swift <steve.j.swift@xxxxxxxxx> wrote: > >> I setup my apache to: >> Listen *:80 >> and it uses all four NICs in my box >> >> >> On 26/11/06, tim <TimJowers@xxxxxxxxxxx > wrote: >> > Has anyone setup their home/SBA network with Apache on one computer >> but >> > serving content on two networks (DSL and cable)? I tried this but >> Apache >> > fails to reply on the secondary network. (It works with only 1 network >> > card in the box.) I have not done a TCP trace yet but does anyone have >> > Apache serving content on two NICs? For me it only replies on the >> > primary it seems. This could also be a problem of needing to manually >> > setup the routing tables but just want to know if anyone has this >> > working before I labor down that road. >> > >> > Here is some more detail: >> > 1. DSL network. 192.168.2.0 >> > 2. Cable network: 192.168.0.0 >> > Hosts /etc/hosts: >> > 127.0.0.1 localhost.localdomain localhost >> > 192.168.0.13 www.serviza.com >> > Apache config: /etc/httpd/conf/httpd.conf >> > Listen 80 >> > #Listen 192.168.2.102:80 # Thought I could toggle the NIC with this >> but >> > fails to respond. >> > ServerName 192.168.0.13:80 >> > #ServerName serviza.com:80 # Argh! Virtual Hosts fails with this - >> > maybe due to /etc/hosts? >> > Route route -n: >> > Destination Gateway Genmask Flags Metric Ref >> Use >> > Iface >> > 192.168.2.0 0.0.0.0 255.255.255.0 U 0 >> 0 0 >> eth0 >> > 192.168.0.0 0.0.0.0 255.255.255.0 U 0 >> 0 0 >> eth1 >> > 169.254.0.0 0.0.0.0 255.255.0.0 U 0 >> 0 0 >> eth1 >> > 0.0.0.0 192.168.0.1 0.0.0.0 UG 0 >> 0 0 >> eth1 >> > # This route does not look right to me. I thought I'd see something >> like: >> > > Destination Gateway Genmask Flags Metric Ref >> > Use Iface >> > > 192.168.2.0 192.168.2.1 255.255.255.0 U 0 >> > 0 0 eth0 >> > > 192.168.0.0 192.168.0.1 255.255.255.0 U 0 >> > 0 0 eth1 >> > # Does not that make more sense? I tried setting these in >> > system-config-network but does not seem to take as the changes do not >> > show in route -n. >> > >> > Thanks a bunch, >> > TimJowers >> > P.S> Running on CentOS (built from RHEL sources) or FC6. I tried >> > searching alot but the terms are too generic so no good matches were >> > found. Mostly the results were about running two instances of Apache. >> > >> > >> --------------------------------------------------------------------- >> > The official User-To-User support forum of the Apache HTTP Server >> Project. >> > See <URL:http://httpd.apache.org/userslist.html> for more >> info. >> > To unsubscribe, e-mail: >> users-unsubscribe@xxxxxxxxxxxxxxxx >> > " from the digest: >> users-digest-unsubscribe@xxxxxxxxxxxxxxxx >> > For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx >> > >> > >> >> >> >> -- >> Steve Swift >> http://www.swiftys.org.uk > > > I've successfully done this but I feel your problem lies with your Isp'S. First off, most DSL providers allow incoming connections on port 80, while most cable providers block port http, smtp and Dsn ports. So before racking your brain verifying that your server can do this, make absolutely sure your cable provider allows you to run a server on port 80. Took me several hours to pin the problem to the ISP, hopefully this will save you the trouble I had. If you in fact can host a server through cable provider, respond back and I'll help you trouble shoot. Dan --------------------------------------------------------------------- The official User-To-User support forum of the Apache HTTP Server Project. See <URL:http://httpd.apache.org/userslist.html> for more info. To unsubscribe, e-mail: users-unsubscribe@xxxxxxxxxxxxxxxx " from the digest: users-digest-unsubscribe@xxxxxxxxxxxxxxxx For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx
-- Morgan gangwere "Space does not reflect society, it expresses it." -- Castells, M., Space of Flows, Space of Places: Materials for a Theory of Urbanism in the Information Age, in The Cybercities Reader, S. Graham, Editor. 2004, Routledge: London. p. 82-93. --------------------------------------------------------------------- The official User-To-User support forum of the Apache HTTP Server Project. See <URL:http://httpd.apache.org/userslist.html> for more info. To unsubscribe, e-mail: users-unsubscribe@xxxxxxxxxxxxxxxx " from the digest: users-digest-unsubscribe@xxxxxxxxxxxxxxxx For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx
|