On 04/16/2021 08:51 PM, H wrote: > On 04/16/2021 08:23 PM, Jonathon Koyle wrote: >>> The OP, ie me, just read up on virtual host configuration. I now understand that it is not possible to have site1.conf and site2.conf as in my first e-mail where I wanted to access the different sites using 1.2.3.4/site1 and 1.2.3.4/site2 etc. >>> >>> My reading suggests that instead accessing them as site1.1.2.3.4 and site2.1.2.3.4 should work with the following minimal conf >> ServerName should either be a hostname or an IP Address. Httpd is >> going to compare this value to the HOST header in an HTTP request and >> it should match what you are putting in host section of the URL For >> example, if you owned example.com the ServerName directives would >> site1.example.com and site2.example.com. >> >> If you are just testing and don't have a domain or DNS, you could just >> set SeverName to site1 and site2 and add entries in your host file >> that map to the IP address >> >> 1.2.3.4 site1 >> 1.2.3.4 site2 >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: users-unsubscribe@xxxxxxxxxxxxxxxx >> For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx >> > I am using one external IP -address for now so you are saying the ServerName should be site1.a.b.c.d and site2.a.b.c.d, respectively, where a.b.c.d is the same? > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: users-unsubscribe@xxxxxxxxxxxxxxxx > For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx > The four sites I have are loading fine - and have through most of this testing BUT, the logging always goes to the access and error log defined in the conf file first in the /etc/httpd/conf.d directory. I understand this is because they are loaded in alphabetical order and defaults to the first one mentioned unless a later match is found. Could there be some /very/ basic configuration I have missed to enable/disable and that's why this occurring? I should also mention that once I have all sites loading and logging done correctly, the next step is to load php-fpm to be able to use different php versions for some of the sites. However, until I have the logging working as intended I am not working on that... --------------------------------------------------------------------- To unsubscribe, e-mail: users-unsubscribe@xxxxxxxxxxxxxxxx For additional commands, e-mail: users-help@xxxxxxxxxxxxxxxx
|