From: George Shen <george.shen@xxxxxxx> [Why] Certain high resolution displays exhibit DCC line corruption with SubVP enabled. This is likely due to insufficient DCC meta data buffered immediately after the mclk switch. [How] Add workaround to increase phantom pipe vactive height by meta_row_height number of lines, thus increasing the amount of meta data buffered immediately after mclk switch finishes. Reviewed-by: Alvin Lee <Alvin.Lee2@xxxxxxx> Acked-by: Tom Chung <chiahsuan.chung@xxxxxxx> Signed-off-by: George Shen <george.shen@xxxxxxx> --- drivers/gpu/drm/amd/display/dc/dml/dcn32/dcn32_fpu.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/gpu/drm/amd/display/dc/dml/dcn32/dcn32_fpu.c b/drivers/gpu/drm/amd/display/dc/dml/dcn32/dcn32_fpu.c index dadaac249836..0b1e721be33b 100644 --- a/drivers/gpu/drm/amd/display/dc/dml/dcn32/dcn32_fpu.c +++ b/drivers/gpu/drm/amd/display/dc/dml/dcn32/dcn32_fpu.c @@ -531,9 +531,11 @@ void dcn32_set_phantom_stream_timing(struct dc *dc, unsigned int i, pipe_idx; struct pipe_ctx *pipe; uint32_t phantom_vactive, phantom_bp, pstate_width_fw_delay_lines; + unsigned int num_dpp; unsigned int vlevel = context->bw_ctx.dml.vba.VoltageLevel; unsigned int dcfclk = context->bw_ctx.dml.vba.DCFCLKState[vlevel][context->bw_ctx.dml.vba.maxMpcComb]; unsigned int socclk = context->bw_ctx.dml.vba.SOCCLKPerState[vlevel]; + struct vba_vars_st *vba = &context->bw_ctx.dml.vba; dc_assert_fp_enabled(); @@ -569,6 +571,11 @@ void dcn32_set_phantom_stream_timing(struct dc *dc, phantom_vactive = get_subviewport_lines_needed_in_mall(&context->bw_ctx.dml, pipes, pipe_cnt, pipe_idx) + pstate_width_fw_delay_lines + dc->caps.subvp_swath_height_margin_lines; + // W/A for DCC corruption with certain high resolution timings. + // Determing if pipesplit is used. If so, add meta_row_height to the phantom vactive. + num_dpp = vba->NoOfDPP[vba->VoltageLevel][vba->maxMpcComb][vba->pipe_plane[pipe_idx]]; + phantom_vactive += num_dpp > 1 ? vba->meta_row_height[vba->pipe_plane[pipe_idx]] : 0; + // For backporch of phantom pipe, use vstartup of the main pipe phantom_bp = get_vstartup(&context->bw_ctx.dml, pipes, pipe_cnt, pipe_idx); -- 2.25.1
