From: Paul Hsieh <paul.hsieh@xxxxxxx> [ Upstream commit bd4905a9583c760da31ded7256dca6f71483c3dc ] [WHY] On customer board, there is one pluse (1v , < 1ms) on DDC_CLK pin when plug / unplug DP cable. Driver will read it and config DP to HDMI/DVI dongle. [HOW] If there is a real dongle, DDC_CLK should be always pull high. Try to read again to recovery this special case. Retry times = 3. Need additional 3ms to detect DP passive dongle(3 failures) Signed-off-by: Paul Hsieh <paul.hsieh@xxxxxxx> Reviewed-by: Eric Yang <eric.yang2@xxxxxxx> Acked-by: Leo Li <sunpeng.li@xxxxxxx> Signed-off-by: Alex Deucher <alexander.deucher@xxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/gpu/drm/amd/display/dc/core/dc_link.c | 23 ++++++++++++++----- 1 file changed, 17 insertions(+), 6 deletions(-) diff --git a/drivers/gpu/drm/amd/display/dc/core/dc_link.c b/drivers/gpu/drm/amd/display/dc/core/dc_link.c index 7c89785fd731..23a7ef97afdd 100644 --- a/drivers/gpu/drm/amd/display/dc/core/dc_link.c +++ b/drivers/gpu/drm/amd/display/dc/core/dc_link.c @@ -324,7 +324,7 @@ bool dc_link_is_dp_sink_present(struct dc_link *link) { enum gpio_result gpio_result; uint32_t clock_pin = 0; - + uint8_t retry = 0; struct ddc *ddc; enum connector_id connector_id = @@ -353,11 +353,22 @@ bool dc_link_is_dp_sink_present(struct dc_link *link) return present; } - /* Read GPIO: DP sink is present if both clock and data pins are zero */ - /* [anaumov] in DAL2, there was no check for GPIO failure */ - - gpio_result = dal_gpio_get_value(ddc->pin_clock, &clock_pin); - ASSERT(gpio_result == GPIO_RESULT_OK); + /* + * Read GPIO: DP sink is present if both clock and data pins are zero + * + * [W/A] plug-unplug DP cable, sometimes customer board has + * one short pulse on clk_pin(1V, < 1ms). DP will be config to HDMI/DVI + * then monitor can't br light up. Add retry 3 times + * But in real passive dongle, it need additional 3ms to detect + */ + do { + gpio_result = dal_gpio_get_value(ddc->pin_clock, &clock_pin); + ASSERT(gpio_result == GPIO_RESULT_OK); + if (clock_pin) + udelay(1000); + else + break; + } while (retry++ < 3); present = (gpio_result == GPIO_RESULT_OK) && !clock_pin; -- 2.19.1 _______________________________________________ amd-gfx mailing list amd-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/amd-gfx