Call drm_client_setup() to run the kernel's default client setup
for DRM. Set fbdev_probe in struct drm_driver, so that the client
setup can start the common fbdev client.
The loongson driver specifies a preferred color mode of 32. As this
is the default if no format has been given, leave it out entirely.
v5:
- select DRM_CLIENT_SELECTION
Signed-off-by: Thomas Zimmermann <tzimmermann@xxxxxxx>
Cc: Sui Jingfeng <suijingfeng@xxxxxxxxxxx>
Acked-by: Sui Jingfeng <sui.jingfeng@xxxxxxxxx>
---
drivers/gpu/drm/loongson/Kconfig | 1 +
drivers/gpu/drm/loongson/lsdc_drv.c | 4 +++-
2 files changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/loongson/Kconfig b/drivers/gpu/drm/loongson/Kconfig
index 9ed463a76ae2..552edfec7afb 100644
--- a/drivers/gpu/drm/loongson/Kconfig
+++ b/drivers/gpu/drm/loongson/Kconfig
@@ -4,6 +4,7 @@ config DRM_LOONGSON
tristate "DRM support for Loongson Graphics"
depends on DRM && PCI && MMU
depends on LOONGARCH || MIPS || COMPILE_TEST
+ select DRM_CLIENT_SELECTION
select DRM_KMS_HELPER
select DRM_TTM
select DRM_TTM_HELPER
diff --git a/drivers/gpu/drm/loongson/lsdc_drv.c b/drivers/gpu/drm/loongson/lsdc_drv.c
index adc7344d2f80..a19dce35c839 100644
--- a/drivers/gpu/drm/loongson/lsdc_drv.c
+++ b/drivers/gpu/drm/loongson/lsdc_drv.c
@@ -9,6 +9,7 @@
#include <drm/drm_aperture.h>
#include <drm/drm_atomic.h>
#include <drm/drm_atomic_helper.h>
+#include <drm/drm_client_setup.h>
#include <drm/drm_drv.h>
#include <drm/drm_fbdev_ttm.h>
#include <drm/drm_gem_framebuffer_helper.h>
@@ -47,6 +48,7 @@ static const struct drm_driver lsdc_drm_driver = {
.dumb_create = lsdc_dumb_create,
.dumb_map_offset = lsdc_dumb_map_offset,
.gem_prime_import_sg_table = lsdc_prime_import_sg_table,
+ DRM_FBDEV_TTM_DRIVER_OPS,
};
static const struct drm_mode_config_funcs lsdc_mode_config_funcs = {
@@ -314,7 +316,7 @@ static int lsdc_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
if (ret)
return ret;
- drm_fbdev_ttm_setup(ddev, 32);
+ drm_client_setup(ddev, NULL);
return 0;
}
--
2.46.0
