[PATCH 45/67] drm/amd/display: use preferred link settings for dp signal only

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Wenjing Liu <wenjing.liu@xxxxxxx>

[why]
We set preferred link settings for virtual signal. However we don't support
virtual signal for UHBR link rate. If preferred is set to UHBR link rate, we
will allow virtual signal with UHBR link rate which causes system crashes.

Reviewed-by: Dillon Varone <dillon.varone@xxxxxxx>
Acked-by: Zaeem Mohamed <zaeem.mohamed@xxxxxxx>
Signed-off-by: Wenjing Liu <wenjing.liu@xxxxxxx>
---
 .../dc/link/protocols/link_dp_capability.c    | 24 ++++++++-----------
 1 file changed, 10 insertions(+), 14 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c b/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
index 41bdadc585b3..00974c50e11f 100644
--- a/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
+++ b/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
@@ -930,21 +930,17 @@ bool link_decide_link_settings(struct dc_stream_state *stream,
 
 	memset(link_setting, 0, sizeof(*link_setting));
 
-	/* if preferred is specified through AMDDP, use it, if it's enough
-	 * to drive the mode
-	 */
-	if (link->preferred_link_setting.lane_count !=
-			LANE_COUNT_UNKNOWN &&
-			link->preferred_link_setting.link_rate !=
-					LINK_RATE_UNKNOWN) {
+	if (dc_is_dp_signal(stream->signal)  &&
+			link->preferred_link_setting.lane_count != LANE_COUNT_UNKNOWN &&
+			link->preferred_link_setting.link_rate != LINK_RATE_UNKNOWN) {
+		/* if preferred is specified through AMDDP, use it, if it's enough
+		 * to drive the mode
+		 */
 		*link_setting = link->preferred_link_setting;
-		return true;
-	}
-
-	/* MST doesn't perform link training for now
-	 * TODO: add MST specific link training routine
-	 */
-	if (stream->signal == SIGNAL_TYPE_DISPLAY_PORT_MST) {
+	} else if (stream->signal == SIGNAL_TYPE_DISPLAY_PORT_MST) {
+		/* MST doesn't perform link training for now
+		 * TODO: add MST specific link training routine
+		 */
 		decide_mst_link_settings(link, link_setting);
 	} else if (link->connector_signal == SIGNAL_TYPE_EDP) {
 		/* enable edp link optimization for DSC eDP case */
-- 
2.34.1




[Index of Archives]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux