In current implementation, when opening a PCM substream, it's needed to
check whether the opposite PCM substream runs. This is to assign
effectual constraints (e.g. sampling rate) to opened PCM substream.
The number of PCM substreams and MIDI substreams on AMDTP streams in
domain is recorded in own structure. Usage of this count is an
alternative of the above check. This is better because the count is
incremented in pcm.hw_params earlier than pcm.trigger.
This idea has one issue because it's incremented for MIDI substreams as
well. In current implementation, for a case that any MIDI substream run
and a PCM substream is going to start, PCM application to start the PCM
substream can decide hardware parameters by restart packet streaming.
Just checking the substream count can brings regression.
Now AMDTP domain structure has a member for the size of PCM period in
PCM substream which starts AMDTP streams in domain. When the value has
zero and the substream count is greater than 1, it means that any MIDI
substream starts AMDTP streams in domain. Usage of the value can resolve
the above issue.
This commit replaces the check with the substream count and the value for
the size of PCM period.
I note that DOT AMDTP protocol has a quirk to use different transmission
method of IEC 61883-6 for tx/rx streams; non-blocking in tx stream and
blocking in rx stream. Although the difference of transmission method
between tx/rx streams precisely brings different timing for a certain
amount of events due to their different calculation for data blocks per
packet, it's possible to approximate enough amount of events mostly has
the same timing. Actually current ALSA IEC 61883-1/6 engine uses large
amount of data blocks for each hardware IRQ (=16 packets).
Signed-off-by: Takashi Sakamoto <o-takashi@xxxxxxxxxxxxx>
---
sound/firewire/digi00x/digi00x-pcm.c | 35 ++++++++++++++++++++++------
1 file changed, 28 insertions(+), 7 deletions(-)
diff --git a/sound/firewire/digi00x/digi00x-pcm.c b/sound/firewire/digi00x/digi00x-pcm.c
index 9ced309d61fa..8dbfb3ff17f6 100644
--- a/sound/firewire/digi00x/digi00x-pcm.c
+++ b/sound/firewire/digi00x/digi00x-pcm.c
@@ -100,14 +100,14 @@ static int pcm_init_hw_params(struct snd_dg00x *dg00x,
static int pcm_open(struct snd_pcm_substream *substream)
{
struct snd_dg00x *dg00x = substream->private_data;
+ struct amdtp_domain *d = &dg00x->domain;
enum snd_dg00x_clock clock;
bool detect;
- unsigned int rate;
int err;
err = snd_dg00x_stream_lock_try(dg00x);
if (err < 0)
- goto end;
+ return err;
err = pcm_init_hw_params(dg00x, substream);
if (err < 0)
@@ -127,19 +127,40 @@ static int pcm_open(struct snd_pcm_substream *substream)
}
}
+ mutex_lock(&dg00x->mutex);
+
+ // When source of clock is not internal or any stream is reserved for
+ // transmission of PCM frames, the available sampling rate is limited
+ // at current one.
if ((clock != SND_DG00X_CLOCK_INTERNAL) ||
- amdtp_stream_pcm_running(&dg00x->rx_stream) ||
- amdtp_stream_pcm_running(&dg00x->tx_stream)) {
+ (dg00x->substreams_counter > 0 && d->events_per_period > 0)) {
+ unsigned int frames_per_period = d->events_per_period;
+ unsigned int rate;
+
err = snd_dg00x_stream_get_external_rate(dg00x, &rate);
- if (err < 0)
+ if (err < 0) {
+ mutex_unlock(&dg00x->mutex);
goto err_locked;
+ }
substream->runtime->hw.rate_min = rate;
substream->runtime->hw.rate_max = rate;
+
+ if (frames_per_period > 0) {
+ err = snd_pcm_hw_constraint_minmax(substream->runtime,
+ SNDRV_PCM_HW_PARAM_PERIOD_SIZE,
+ frames_per_period, frames_per_period);
+ if (err < 0) {
+ mutex_unlock(&dg00x->mutex);
+ goto err_locked;
+ }
+ }
}
+ mutex_unlock(&dg00x->mutex);
+
snd_pcm_set_sync(substream);
-end:
- return err;
+
+ return 0;
err_locked:
snd_dg00x_stream_lock_release(dg00x);
return err;
--
2.20.1
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
