From: Bard Liao <yung-chuan.liao@xxxxxxxxxxxxxxx> There are two issues, likely copy/paste: 1. Use cdns->pcm.num_in instead of stream_num_in for consistency with the rest of the code. This was not detected earlier since platforms did not have input-only PDIs. 2. use the correct offset for bi-dir PDM, based on IN and OUT PDIs. Again this was not detected since PDM was not supported earlier. Reported-by: Ranjani Sridharan <ranjani.sridharan@xxxxxxxxxxxxxxx> Signed-off-by: Bard Liao <yung-chuan.liao@xxxxxxxxxxxxxxx> Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxxxxxxxx> --- drivers/soundwire/intel.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/soundwire/intel.c b/drivers/soundwire/intel.c index 2443b9b32b46..1814f6168801 100644 --- a/drivers/soundwire/intel.c +++ b/drivers/soundwire/intel.c @@ -901,7 +901,7 @@ static int intel_register_dai(struct sdw_intel *sdw) /* Create PCM DAIs */ stream = &cdns->pcm; - ret = intel_create_dai(cdns, dais, INTEL_PDI_IN, stream->num_in, + ret = intel_create_dai(cdns, dais, INTEL_PDI_IN, cdns->pcm.num_in, off, stream->num_ch_in, true); if (ret) return ret; @@ -932,7 +932,7 @@ static int intel_register_dai(struct sdw_intel *sdw) if (ret) return ret; - off += cdns->pdm.num_bd; + off += cdns->pdm.num_out; ret = intel_create_dai(cdns, dais, INTEL_PDI_BD, cdns->pdm.num_bd, off, stream->num_ch_bd, false); if (ret) -- 2.20.1 _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx https://mailman.alsa-project.org/mailman/listinfo/alsa-devel