Dne četrtek, 05. september 2019 ob 11:43:25 CEST je Cheng-Yi Chiang napisal(a): > From: Yakir Yang <ykk@xxxxxxxxxxxxxx> > > When transmitting IEC60985 linear PCM audio, we configure the > Aduio Sample Channel Status information of all the channel > status bits in the IEC60958 frame. > Refer to 60958-3 page 10 for frequency, original frequency, and > wordlength setting. > > This fix the issue that audio does not come out on some monitors > (e.g. LG 22CV241) > > Note that these registers are only for interfaces: > I2S audio interface, General Purpose Audio (GPA), or AHB audio DMA > (AHBAUDDMA). > For S/PDIF interface this information comes from the stream. > > Currently this function dw_hdmi_set_channel_status is only called > from dw-hdmi-i2s-audio in I2S setup. > > Signed-off-by: Yakir Yang <ykk@xxxxxxxxxxxxxx> > Signed-off-by: Cheng-Yi Chiang <cychiang@xxxxxxxxxxxx> > --- > Original patch by Yakir Yang is at > > https://lore.kernel.org/patchwork/patch/539653/ > > Change from v1 to v2: > 1. Remove the version check because this will only be called by > dw-hdmi-i2s-audio, and the registers are available in I2S setup. > 2. Set these registers in dw_hdmi_i2s_hw_params. > 3. Fix the sample width setting so it can use 16 or 24 bits. > > .../drm/bridge/synopsys/dw-hdmi-i2s-audio.c | 1 + > drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 70 +++++++++++++++++++ > drivers/gpu/drm/bridge/synopsys/dw-hdmi.h | 20 ++++++ > include/drm/bridge/dw_hdmi.h | 2 + > 4 files changed, 93 insertions(+) > > diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c > b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c index > 34d8e837555f..b801a28b0f17 100644 > --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c > +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c > @@ -102,6 +102,7 @@ static int dw_hdmi_i2s_hw_params(struct device *dev, > void *data, } > > dw_hdmi_set_sample_rate(hdmi, hparms->sample_rate); > + dw_hdmi_set_channel_status(hdmi, hparms->sample_width); > dw_hdmi_set_channel_count(hdmi, hparms->channels); > dw_hdmi_set_channel_allocation(hdmi, hparms- >cea.channel_allocation); > > diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c > b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c index > bd65d0479683..d1daa369c8ae 100644 > --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c > +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c > @@ -582,6 +582,76 @@ static unsigned int hdmi_compute_n(unsigned int freq, > unsigned long pixel_clk) return n; > } > > +/* > + * When transmitting IEC60958 linear PCM audio, these registers allow to > + * configure the channel status information of all the channel status > + * bits in the IEC60958 frame. For the moment this configuration is only > + * used when the I2S audio interface, General Purpose Audio (GPA), > + * or AHB audio DMA (AHBAUDDMA) interface is active > + * (for S/PDIF interface this information comes from the stream). > + */ > +void dw_hdmi_set_channel_status(struct dw_hdmi *hdmi, > + unsigned int sample_width) > +{ > + u8 aud_schnl_samplerate; > + u8 aud_schnl_8; > + u8 word_length_bits; > + > + switch (hdmi->sample_rate) { > + case 32000: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_32K; > + break; > + case 44100: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_44K1; > + break; > + case 48000: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_48K; > + break; > + case 88200: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_88K2; > + break; > + case 96000: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_96K; > + break; > + case 176400: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_176K4; > + break; > + case 192000: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_192K; > + break; > + case 768000: > + aud_schnl_samplerate = HDMI_FC_AUDSCHNLS7_SMPRATE_768K; > + break; > + default: > + dev_warn(hdmi->dev, "Unsupported audio sample rate (%u) \n", > + hdmi->sample_rate); > + return; > + } > + > + /* set channel status register */ > + hdmi_modb(hdmi, aud_schnl_samplerate, HDMI_FC_AUDSCHNLS7_SMPRATE_MASK, > + HDMI_FC_AUDSCHNLS7); > + > + /* > + * Set original frequency to be the same as frequency. > + * Use one-complement value as stated in IEC60958-3 page 13. > + */ > + aud_schnl_8 = (~aud_schnl_samplerate) << > + HDMI_FC_AUDSCHNLS8_ORIGSAMPFREQ_OFFSET; > + > + /* > + * Refer to IEC60958-3 page 12. We can accept 16 bits or 24 bits. > + * Otherwise, set the register to 0t o indicate using default value. Nit: "0t 0" -> "0 to" With that fixed, this patch is: Reviewed-by: Jernej Skrabec <jernej.skrabec@xxxxxxxx> Best regards, Jernej > + */ > + word_length_bits = (sample_width == 16) ? 0x2 : > + ((sample_width == 24) ? 0xb : 0); > + > + aud_schnl_8 |= word_length_bits << HDMI_FC_AUDSCHNLS8_WORDLEGNTH_OFFSET; > + > + hdmi_writeb(hdmi, aud_schnl_8, HDMI_FC_AUDSCHNLS8); > +} > +EXPORT_SYMBOL_GPL(dw_hdmi_set_channel_status); > + > static void hdmi_set_clk_regenerator(struct dw_hdmi *hdmi, > unsigned long pixel_clk, unsigned int sample_rate) > { > diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h > b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h index > 6988f12d89d9..619ebc1c8354 100644 > --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h > +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h > @@ -158,6 +158,17 @@ > #define HDMI_FC_SPDDEVICEINF 0x1062 > #define HDMI_FC_AUDSCONF 0x1063 > #define HDMI_FC_AUDSSTAT 0x1064 > +#define HDMI_FC_AUDSV 0x1065 > +#define HDMI_FC_AUDSU 0x1066 > +#define HDMI_FC_AUDSCHNLS0 0x1067 > +#define HDMI_FC_AUDSCHNLS1 0x1068 > +#define HDMI_FC_AUDSCHNLS2 0x1069 > +#define HDMI_FC_AUDSCHNLS3 0x106a > +#define HDMI_FC_AUDSCHNLS4 0x106b > +#define HDMI_FC_AUDSCHNLS5 0x106c > +#define HDMI_FC_AUDSCHNLS6 0x106d > +#define HDMI_FC_AUDSCHNLS7 0x106e > +#define HDMI_FC_AUDSCHNLS8 0x106f > #define HDMI_FC_DATACH0FILL 0x1070 > #define HDMI_FC_DATACH1FILL 0x1071 > #define HDMI_FC_DATACH2FILL 0x1072 > @@ -706,6 +717,15 @@ enum { > /* HDMI_FC_AUDSCHNLS7 field values */ > HDMI_FC_AUDSCHNLS7_ACCURACY_OFFSET = 4, > HDMI_FC_AUDSCHNLS7_ACCURACY_MASK = 0x30, > + HDMI_FC_AUDSCHNLS7_SMPRATE_MASK = 0x0f, > + HDMI_FC_AUDSCHNLS7_SMPRATE_192K = 0xe, > + HDMI_FC_AUDSCHNLS7_SMPRATE_176K4 = 0xc, > + HDMI_FC_AUDSCHNLS7_SMPRATE_96K = 0xa, > + HDMI_FC_AUDSCHNLS7_SMPRATE_768K = 0x9, > + HDMI_FC_AUDSCHNLS7_SMPRATE_88K2 = 0x8, > + HDMI_FC_AUDSCHNLS7_SMPRATE_32K = 0x3, > + HDMI_FC_AUDSCHNLS7_SMPRATE_48K = 0x2, > + HDMI_FC_AUDSCHNLS7_SMPRATE_44K1 = 0x0, > > /* HDMI_FC_AUDSCHNLS8 field values */ > HDMI_FC_AUDSCHNLS8_ORIGSAMPFREQ_MASK = 0xf0, > diff --git a/include/drm/bridge/dw_hdmi.h b/include/drm/bridge/dw_hdmi.h > index cf528c289857..12144d2f80f4 100644 > --- a/include/drm/bridge/dw_hdmi.h > +++ b/include/drm/bridge/dw_hdmi.h > @@ -156,6 +156,8 @@ void dw_hdmi_setup_rx_sense(struct dw_hdmi *hdmi, bool > hpd, bool rx_sense); > > void dw_hdmi_set_sample_rate(struct dw_hdmi *hdmi, unsigned int rate); > void dw_hdmi_set_channel_count(struct dw_hdmi *hdmi, unsigned int cnt); > +void dw_hdmi_set_channel_status(struct dw_hdmi *hdmi, > + unsigned int sample_width); > void dw_hdmi_set_channel_allocation(struct dw_hdmi *hdmi, unsigned int ca); > void dw_hdmi_audio_enable(struct dw_hdmi *hdmi); > void dw_hdmi_audio_disable(struct dw_hdmi *hdmi); _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
