On Fri, Aug 02, 2019 at 03:51:09PM +0100, Thomas Preston wrote: > On 02/08/2019 12:10, Mark Brown wrote: > > You can use a read only control for the readback, or just have it be > > triggered by overwriting the readback value. You can cache the result. > Keeping the trigger and result together like that would be better I think, > although the routine isn't supposed to run mid way through playback. If > we're mid playback the debugfs routine has to turn off AMP_ON, take the > device back to a known state, run diagnostics, then restore. Which causes > a gap in the audible sound. Whatever method is used to do the triggering can always return -EBUSY when you someone tries to do so during playback. > >> Kirill Marinushkin mentioned this in the first review [0], it just didn't > >> really sink in until now! > > You could do that too, yeah. Depends on what this is diagnosing and if > > that'd be useful. > The diagnostic status bits describe situations such as: > - open load (no speaker connected) > - short to GND > - short to VCC > - etc > The intention is to test if all the speakers are connected. So, one might > have a self test which runs the diagnostic and verifies it outputs: ... > I think the module parameter method is more appropriate for a > "Turn-on diagnostic", even though I don't really like grepping dmesg > for the result. I'll go ahead and implement that unless anyone has a > particular preference for the kcontrol-trigger. Right. It's not ideal for use in production systems for example but perhaps fine for support techs or whoever. Up to you anyway.
Attachment:
signature.asc
Description: PGP signature
_______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
