On Thu, Jun 27, 2019 at 8:05 PM Codrin Ciubotariu
<codrin.ciubotariu@xxxxxxxxxxxxx> wrote:
> +struct ad193x_reg_default {
> + unsigned int reg;
> + unsigned int val;
> +};
You probably don't need to define this. There is a struct
reg_sequence in regmap.h.
> +
> +/* codec register values to set after reset */
> +static void ad193x_reg_default_init(struct ad193x_priv *ad193x)
> +{
> + const struct ad193x_reg_default reg_init[] = {
> + { 0, 0x99 }, /* PLL_CLK_CTRL0: pll input: mclki/xi 12.288Mhz */
> + { 1, 0x04 }, /* PLL_CLK_CTRL1: no on-chip Vref */
> + { 2, 0x40 }, /* DAC_CTRL0: TDM mode */
> + { 4, 0x1A }, /* DAC_CTRL2: 48kHz de-emphasis, unmute dac */
> + { 5, 0x00 }, /* DAC_CHNL_MUTE: unmute DAC channels */
> + };
> + const struct ad193x_reg_default reg_adc_init[] = {
> + { 14, 0x03 }, /* ADC_CTRL0: high-pass filter enable */
> + { 15, 0x43 }, /* ADC_CTRL1: sata delay=1, adc aux mode */
> + };
> + int i;
> +
> + for (i = 0; i < ARRAY_SIZE(reg_init); i++)
> + regmap_write(ad193x->regmap, reg_init[i].reg, reg_init[i].val);
> +
> + if (ad193x_has_adc(ad193x)) {
> + for (i = 0; i < ARRAY_SIZE(reg_adc_init); i++) {
> + regmap_write(ad193x->regmap, reg_adc_init[i].reg,
> + reg_adc_init[i].val);
> + }
> + }
And you could use regmap_multi_reg_write( ) to substitute the two for-loops.
See https://mailman.alsa-project.org/pipermail/alsa-devel/2019-June/151090.html
as an example. It also has some reg initializations in component
probe( ).
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
