On Fri, May 17, 2019 at 4:13 AM Maxime Ripard <maxime.ripard@xxxxxxxxxxx> wrote:
>
> On Wed, May 15, 2019 at 06:27:49PM +0300, Georgii Staroselskii wrote:
> > On Wed, May 15, 2019 at 03:58:13PM +0200, Maxime Ripard wrote:
> > > > diff --git a/sound/soc/sunxi/sun4i-codec.c b/sound/soc/sunxi/sun4i-codec.c
> > > > index 15d08e3..e0099519 100644
> > > > --- a/sound/soc/sunxi/sun4i-codec.c
> > > > +++ b/sound/soc/sunxi/sun4i-codec.c
> > > > @@ -1329,6 +1329,15 @@ static int sun4i_codec_spk_event(struct snd_soc_dapm_widget *w,
> > > > gpiod_set_value_cansleep(scodec->gpio_pa,
> > > > !!SND_SOC_DAPM_EVENT_ON(event));
> > > >
> > > > + if (SND_SOC_DAPM_EVENT_ON(event)) {
> > > > + /*
> > > > + * Need a delay to have the amplifier up. 700ms seems the best
> > > > + * compromise between the time to let the amplifier up and the
> > > > + * time not to feel this delay while playing a sound.
> > > > + */
> > > > + msleep(700);
> > > > + }
> > > > +
> > >
> > > Since this is an external amplifier, I guess they would have different
> > > warm-up time depending on the exact part being used?
> >
> > I guess I might've used Speaker wrong and bumped into an existing
> > issue. The issue first arose when I needed to connect a speaker and
> > use a mute GPIO pin to toggle it. I bumped into the lag similar to
> > the one that has been fixed in bf14da7. The word "amplifier" here in
> > my comments might be wrong and misleding. Sorry for that. I just
> > measured the latency on the speaker I'm using and it is well under
> > 1ms so this is the Allwinner DAC that is pushing the data with a
> > lag. Or some other thing, I'm not sure.
> >
> > I want to stress again that I might've experienced the issue because
> > I was abusing "Speaker" routing. I basically just needed the analog
> > audio stream and mute GPIO handling done automatically.
>
> Ok. I guess the comment should just be reflecting that then.
Sounds like the board has an external buffer / amplifier for the speaker.
Does it have a headphone jack that bypasses it? Then you could check for
the actual latency.
Also, I think it might be better if we could move to actual audio routing
and have a simple-amplifier instead.
ChenYu
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
