On Thu, Apr 18, 2019 at 02:37:03AM +0000, S.j. Wang wrote:
> > Here:
> > > + /* Does not support cases: Tsout > 8.125 * Tsin */
> > > + if (inrate * 8 > 65 * outrate)
Though it might not matter any more (see my last comments),
it should be "inrate > 8.125 * outrate" in the comments.
> > > + return -EINVAL;
> > And here:
> > > + ret = fsl_asrc_sel_proc(inrate, outrate, &pre_proc, &post_proc);
> > > + if (ret) {
> > > + pair_err("No supported pre-processing options\n");
> > > + return ret;
> > > + }
> >
> > Instead of a general message, I was thinking of a more specific one by
> > telling users that the ratio between the two rates isn't supported --
> > something similar to what I suggested previously:
> >
> > pair_err("Does not support %d (input) > 8.125 * %d (output)\n",
> > outrate, inrate);
> >
> In fsl_asrc_sel_proc, we can't call the pair_err for there is no
> struct fsl_asrc_pair *pair in the argument. Do you think we need to
> add this argument?
I's thinking of adding it to the top of fsl_asrc_config_pair()
as a part of inrate-outrate-validation, however, I found that
actually we already have a similar check in the early routine:
if ((outrate > 8000 && outrate < 30000) &&
(outrate/inrate > 24 || inrate/outrate > 8)) {
pair_err("exceed supported ratio range [1/24, 8] for \
inrate/outrate: %d/%d\n", inrate, outrate);
return -EINVAL;
}
And this is according to IMX6DQRM:
Limited support for the case when output sampling rates is
between 8kHz and 30kHz. The limitation is the supported ratio
(Fsin/Fsout) range as between 1/24 to 8
This should cover your 8.125 condition already, even if having
an outrate range between [8KHz, 30KHz] check, since an outrate
above 30KHz will not have an inrate bigger than 8.125 times of
it, given the maximum input rate is 192KHz.
So I think that we can just drop that 8.125 condition from your
change and there's no need to error out any more.
However, we do need a patch to fix a potential rounding issue:
- (outrate/inrate > 24 || inrate/outrate > 8)) {
+ (outrate > 24 * inrate || inrate > 8 * outrate)) {
Should fix the missing whitespace also. And it will be needed
to send to stable kernel too. Will you help submit a change?
Thanks
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
