On 25/01/2019 12:40, Takashi Iwai wrote:
> On Fri, 25 Jan 2019 12:36:00 +0100,
> Jon Hunter wrote:
>>
>>
>> On 24/01/2019 19:08, Takashi Iwai wrote:
>>> On Thu, 24 Jan 2019 18:36:43 +0100,
>>> Sameer Pujar wrote:
>>>>
>>>> If CONFIG_PM is disabled or runtime PM calls are forbidden, the clocks
>>>> will not be ON. This could cause issue during probe, where hda init
>>>> setup is done. This patch checks whether runtime PM is enabled or not.
>>>> If disabled, clocks are enabled in probe() and disabled in remove()
>>>>
>>>> This patch does following minor changes as cleanup,
>>>> * return code check for pm_runtime_get_sync() to take care of failure
>>>> and exit gracefully.
>>>> * In remove path runtime PM is disabled before calling snd_card_free().
>>>> * hda_tegra_disable_clocks() is moved out of CONFIG_PM_SLEEP check.
>>>> * runtime PM callbacks moved out of CONFIG_PM check
>>>>
>>>> Signed-off-by: Sameer Pujar <spujar@xxxxxxxxxx>
>>>> Reviewed-by: Ravindra Lokhande <rlokhande@xxxxxxxxxx>
>>>> Reviewed-by: Jon Hunter <jonathanh@xxxxxxxxxx>
>>> (snip)
>>>> @@ -555,6 +553,13 @@ static int hda_tegra_probe(struct platform_device *pdev)
>>>> if (!azx_has_pm_runtime(chip))
>>>> pm_runtime_forbid(hda->dev);
>>>>
>>>> + /* explicit resume if runtime PM is disabled */
>>>> + if (!pm_runtime_enabled(hda->dev)) {
>>>> + err = hda_tegra_runtime_resume(hda->dev);
>>>> + if (err)
>>>> + goto out_free;
>>>> + }
>>>> +
>>>> schedule_work(&hda->probe_work);
>>>
>>> Calling runtime_resume here is really confusing...
>>
>> Why? IMO it is better to have a single handler for resuming the device
>> and so if RPM is not enabled we call the handler directly. This is what
>> we have been advised to do in the past and do in other drivers. See ...
>
> The point is that we're not "resuming" anything there. It's in the
> early probe stage, and the device state is uninitialized, not really
> suspended. It'd end up with just calling the same helper
> (hda_tegra_enable_clocks()), though.
Yes and you can make the same argument for every driver that calls
pm_runtime_get_sync() during probe to turn on clocks, handle resets,
etc, because at the end of the day the very first call to
pm_runtime_get_sync() invokes the runtime_resume callback, when we have
never been suspended.
Yes at the end of the day it is the same and given that we have done
this elsewhere I think it is good to be consistent if/where we can.
Furthermore, there are other various drivers in the kernel that do the
same ...
drivers/i2c/busses/i2c-img-scb.c
drivers/dma/xilinx/zynqmp_dma.c
drivers/gpu/drm/arm/malidp_drv.c
Cheers
Jon
--
nvpublic
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
