DSP_RUN and DSP_ENABLE needs to be disabled during FW load. This is not
a problem after power-cycling but for soft reboots.
Signed-off-by: Niklas Carlsson <niklasc@xxxxxxxx>
---
sound/soc/codecs/adau1761.c | 29 ++++++++++++++++++++++++++++-
1 file changed, 28 insertions(+), 1 deletion(-)
diff --git a/sound/soc/codecs/adau1761.c b/sound/soc/codecs/adau1761.c
index bef3e9e74c26..3075c13bcbbc 100644
--- a/sound/soc/codecs/adau1761.c
+++ b/sound/soc/codecs/adau1761.c
@@ -460,8 +460,35 @@ static int adau1761_set_bias_level(struct snd_soc_component *component,
regmap_update_bits(adau->regmap, ADAU17X1_CLOCK_CONTROL,
ADAU17X1_CLOCK_CONTROL_SYSCLK_EN,
ADAU17X1_CLOCK_CONTROL_SYSCLK_EN);
- if (snd_soc_component_get_bias_level(component) == SND_SOC_BIAS_OFF)
+ if (snd_soc_component_get_bias_level(component) ==
+ SND_SOC_BIAS_OFF) {
+ /*
+ * When going OFF -> STANDBY, the device can be in two
+ * states:
+ * 1) Power-cycled and reset
+ * 2) Soft reboot
+ * In the case of soft reboot, we need to sync the HW
+ * registers even if our regmap reports default values.
+ * Marking the cache as dirty ensures that both cases
+ * are handled.
+ */
+ regcache_mark_dirty(adau->regmap);
regcache_sync(adau->regmap);
+ /*
+ * In order for FW to load correctly, the device needs
+ * DSP_RUN and DSP_ENABLE to be 0. This might not be the
+ * case for soft reboots. Ensure that DSP_RUN and
+ * DSP_ENABLE is 0 by bypassing the cache and write
+ * directly to HW when going OFF -> STANDBY.
+ */
+ if (adau17x1_has_dsp(adau)) {
+ regcache_cache_bypass(adau->regmap, true);
+ regmap_write(adau->regmap, ADAU17X1_DSP_RUN, 0);
+ regmap_write(adau->regmap,
+ ADAU17X1_DSP_ENABLE, 0);
+ regcache_cache_bypass(adau->regmap, false);
+ }
+ }
break;
case SND_SOC_BIAS_OFF:
regmap_update_bits(adau->regmap, ADAU17X1_CLOCK_CONTROL,
--
2.11.0
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
